ALLIANCE ZWN43RSN115CW01 (01) PDF Document

To enter the Factory Test Procedure on the ALLIANCE ZWN43RSN115CW01, follow these steps:

1. Disconnect electrical power from the unit.

2. Reconnect electrical power to the unit.

3. Wait about 10 seconds.

4. Turn the Cycle Selection knob to the opposite of Normal Eco. Stay on that selection for at least one second.

5. Press and hold the Start/Pause button.

6. Change the Cycle Selection knob to Normal Eco within 5 seconds or the Start press will be invalid.

7. Stay on Normal Eco for at least one second. The control will enter the Factory Test Mode.

8. To advance through the sequence of test steps, press the Start/Pause button.

The Factory Test Procedure for the ALLIANCE ZWN43RSN115CW01 consists of several steps:

If the ALLIANCE ZWN43RSN115CW01 indicates a Pressure Sensor Error (WASH, RINSE lights flash 1 time), follow these steps:

1. Check if the pressure sensor is connected to the front end control properly. If not, connect the sensor to the front end control.

2. Check if the pressure sensor harness is damaged. If it is, replace the pressure sensor harness.

3. If the error is still displayed, replace the pressure sensor. If the problem persists, replace the front end control.

To properly level your ALLIANCE ZWN43RSN115CW01, follow these instructions:

1. Place a level on the cabinet top and check if the washer is level from side to side and front to back.

2. If the washer is not level, tilt the washer back to access the front leveling legs. Loosen the locknuts and adjust the legs by screwing them into or out of the washer base.

3. Once adjusted, tilt the washer forward on the front legs and lower it back down into position to set the rear self-leveling legs.

4. The washer must not rock. When the washer is level and does not rock, tighten the locknuts securely against the bottom of the washer base. If these locknuts are not tight, the washer will not remain stationary during operation.

If your ALLIANCE ZWN43RSN115CW01 is vibrating excessively, check the following:

1. Ensure the shipping plug has been removed from the base.

2. Verify if there is an unbalanced load in the tub. If so, stop the washer, redistribute the load, and restart.

3. Check if any centering springs are broken, disconnected, or in the wrong position. Ensure green springs are in the front two positions.

4. Check if the washer is unleveled. If so, adjust the leveling legs and make sure rear leveling legs are free.

5. Check if the washer is installed on a weak, spongy, carpeted, or built-up floor. Relocate the washer or support the floor to eliminate this condition.

6. Check if cabinet screws are incorrect or loose.

7. Check if the base is damaged from being dropped.

8. Check if there is lubricant on the pivot dome and/or base friction ring.

9. Check if a partial liquid filled balance ring is leaking.

10. Check if the friction ring is broken.

When replacing or reinstalling the drive bell on your ALLIANCE ZWN43RSN115CW01, torque the bolts to the following specifications:

Test the mixing valve solenoids on your ALLIANCE ZWN43RSN115CW01 using an Ohm meter. Refer to the table below for expected resistance readings:

Resistance readings slightly out of these ranges may be due to meter conditions and do not necessarily indicate mixing valve failure.