WHIRLPOOL YWMMF5930 (01) PDF DOCUMENT

Step 1. The first time you power up the WHIRLPOOL YWMMF5930, the clock time will be blinking 12:00 on the display.

Step 2. Open the door.

Step 3. Use the number keypad to set the hours and minutes. The range is between 1:00-12:59. It is a 12-hour clock without AM/PM.

Step 4. Press the Settings keypad or wait for 5 seconds to confirm.

Step 1. Open the door.

Step 2. Place food inside the microwave oven.

Step 3. Select food classes.

Step 4. Enter/Sense the amounts.

Step 5. Close the door.

Step 6. Press Start to start the cooking.

Step 7. The Cancel/Stop button can be used to cancel the function during or after cook time.

Press the Light button to set the hood light among HIGH, LOW, and OFF.

Press the Fan/Vent Fan button to set the vent fan among HIGH, MEDIUM, LOW, and OFF.

Always use oven mitts or pot holders when removing dishes from the microwave oven. Aluminum foil and some metal can be used in the microwave oven. If not used properly, arcing (a blue flash of light) can occur and cause damage to the microwave oven.

OK for Use:

■ Browning dish (Follow manufacturer recommendations.)

■ Ceramic glass, glass

■ China, earthenware (Follow manufacturer recommendations.)

■ Melamine (Follow manufacturer recommendations.)

■ Paper towels, paper plates, napkins (Use non-recycled paper.)

■ Plastic wraps, bags, covers, dinnerware, containers (Follow manufacturer recommendations.)

■ Pottery and clay (Follow manufacturer recommendations.)

■ Silicone bakeware (Follow manufacturer recommendations.)

■ Wax paper.

Metal cookware and bakeware, gold, silver, pewter, non-approved meat thermometers, skewers, twist ties, foil liners such as sandwich wrappers, staples, and objects with gold or silver trim or a metallic glaze should not be used in the microwave oven.

The WHIRLPOOL YWMMF5930 has two vent locations:

A. Microwave oven vent: This vent is flushed to the cabinet and opens automatically when the microwave works. It should not be blocked or covered since it allows the inlet of fresh air into the cooling system.

B. Bottom vent: This vent should also not be blocked or covered since it allows the inlet of fresh air into the cooling system and the outlet of hot air from the cooling system.

Blocking or covering vents will cause poor air circulation, affecting cooking, cleaning, and cooling results.

The Grease Filter is located on the underside of the microwave oven and should be cleaned monthly.

To clean the Grease Filter:

1. Disconnect power.

2. To remove the Grease Filter, loosen the screw and slide it out of the bottom plate. Remove the Charcoal Filter.

3. Clean the Grease Filter with a mild cleanser and scouring pad, or clean it in a dishwasher.

4. After cleaning, dry it, reattach the Charcoal Filter, and put the Grease Filter back into the bottom plate. Securely tighten the screw.

If the Grease Filter has been damaged, replace it with a new one.

To replace the Grease Filter:

1. Disconnect power.

2. Remove the old Grease Filter by loosening the screw and sliding it out of the bottom plate. Remove the Charcoal Filter.

3. Replace with a new Grease Filter. Reattach the Charcoal Filter.

4. Put the Grease Filter back into the bottom plate. Securely tighten the screw.

The Charcoal Filter is located behind the Grease Filter. It cannot be cleaned and should be replaced every 6 months. The display will show a filter alert: “Change the Charcoal Filter, Reset reminder in Settings.”

To replace the Charcoal Filter:

1. Disconnect power.

2. Remove the Grease Filter by loosening the screw and sliding it out of the bottom plate.

3. Remove the Charcoal Filter from the Grease Filter.

4. Replace the old Charcoal Filter with a new Charcoal Filter.

5. Put the new Charcoal Filter back into the Grease Filter.

6. Put them back into the bottom plate. Securely tighten the screw.

After the Charcoal Filter is replaced, you can remove the filter alert on the display and retrieve another 6 months of duration.

1. Press the Settings button repeatedly until “Filter Reset” is displayed.

2. The display will scroll “Press 1 to reset filter reminder.”

3. Press the 1 keypad to confirm. “Filter Reset” will appear on the display.

The Charcoal Filter will now retrieve another 6 months of duration.