WESTINGHOUSE WRB5004W (01) PDF Document

Please read the following warnings carefully before installing or using the handle accessory to avoid damage or injury.

ENVIRONMENT:

Remove and discard any packaging material before using this accessory. Most of the packaging materials are recyclable. Please dispose of those materials through your local recycling depot or by placing them in the appropriate collection containers.

WARNING: Risk of suffocation, injury or permanent disability.

This accessory is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety.

This accessory may contain small parts that are a choking hazard. Not suitable for children under 3 years of age.

CAUTION: It is important to use your appliance safely.

Do not use or place the accessory near the edge of the table or counter, near hot gas, stove, electric burner or heated oven.

This accessory is for indoor use only.

This accessory is intended for domestic use only.

When cleaning, use only a soft cloth with an unscented mild soap and lukewarm water.

Never use hot water, solvents, commercial kitchen cleaners, aerosol cleaners, metal polishes, caustic or abrasive cleaners, or scourers to clean the accessory, as they may damage it. Many commercially available cleaning products and detergents contain solvents that will damage your accessory.

The handle components for your refrigerator are packed in two separate locations:

Bar handle: The bar handle is securely packed in the rear left hand EPS corner post packing.

Handle Kit: The handle kit is located in the bottom of your refrigerator crisper or freezer drawer.

The handle installation kit contains the following parts:

Handle bar x1 (located in rear left hand corner eps packaging)

Handle bracket (A) x1

Handle bracket (B) x1

Handle bracket (C) x1

Cover bracket x3

Allen key x1

Screw M5 x3

Screw M4 x6

plug screw hole x6 White

plug screw hole x6 Grey

Follow these steps to assemble the bar handle before attaching it to the door:

1. Using a suitable work space, place the handle bar with screw holes facing up on a soft surface to prevent damage to the handle.

2. Locate and position the three handle brackets on the handle bar so that the pins locate in the holes and screw holes align. The brackets are identified with letters A, B, and C to aid assembly.

3. Using the Allen key, assemble the handle brackets to the handle bar using the M5 screws provided.

4. Ensure all screws are tight.

Follow these steps to attach the handle assembly to the refrigerator door:

1. Identify the correct side of the door to fit the handle (opposite the hinge).

2. Align the screw holes on the handle with the holes in the door.

3. Using the Allen key, attach the handle assembly to the door with the M4 screws provided.

4. Fit one screw finger tight to the middle bracket ‘B’.

5. Fit one screw finger tight to the top and bottom brackets ‘A’ and ‘C’.

6. Ensure the handle is located correctly onto the door.

7. Fit the remaining 3 screws and tighten them.

8. Ensure all screws are tightened.

9. Fit the Covers by clipping them onto the brackets.

To complete the handle installation:

1. Select the plugs of the correct colour to match your refrigerator.

2. Push the plugs into the screw holes on the hinge side of the door.

Your handle installation is now complete.

To change your appliance door opening from left hand to right hand or vice versa, you will need to purchase a door reversal kit part number A05807201.