WESTINGHOUSE WRB5004S (01) PDF Document

Before installing or using the handle accessory for your WESTINGHOUSE WRB5004S, please be aware of the following warnings:

ENVIRONMENT: Remove and discard any packaging material before use. Most packaging materials are recyclable. Please dispose of them through your local recycling depot or in appropriate collection containers.

WARNING – Risk of suffocation, injury or permanent disability:

• This accessory is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a person responsible for their safety.

• This accessory may contain small parts that are a choking hazard. It is not suitable for children under 3 years of age.

CAUTION – Important safety points:

• Do not use or place the accessory near the edge of a table or counter, near a hot gas source, stove, electric burner, or heated oven.

• This accessory is for indoor and domestic use only.

• For cleaning, use only a soft cloth with an unscented mild soap and lukewarm water.

• Never use hot water, solvents, commercial kitchen cleaners, aerosol cleaners, metal polishes, caustic or abrasive cleaners, or scourers to clean the accessory, as they may damage it. Many commercially available cleaning products and detergents contain solvents that will damage your accessory.

The parts for your WESTINGHOUSE WRB5004S handle installation are located in two separate places:

• Bar handle: The bar handle is securely packed in the rear left-hand EPS corner post packing of the appliance.

• Handle Kit: The handle kit is located in the bottom of your refrigerator crisper or freezer drawer.

The handle installation kit for the WESTINGHOUSE WRB5004S contains the following parts:

• Handle bar x1 (located in rear left hand corner eps packaging)

• Handle bracket (A) x1

• Handle bracket (B) x1

• Handle bracket (C) x1

• Cover bracket x3

• Allen key x1

• Screw M5 x3

• Screw M4 x6

• plug screw hole x6 White

• plug screw hole x6 Grey

To assemble the bar handle for your WESTINGHOUSE WRB5004S, follow these steps:

1. Using a suitable work space, place the handle bar with the screw holes facing up on a soft surface to prevent damage.

2. Locate and position the three handle brackets on the handle bar so that the pins on the brackets locate in the holes on the bar and the screw holes align. The brackets are identified with letters A, B, and C to aid in correct placement.

3. Using the provided Allen key, assemble the handle brackets to the handle bar using the M5 screws provided.

4. Ensure all screws are tight.

To attach the handle assembly to the door of your WESTINGHOUSE WRB5004S, follow these instructions:

1. Identify the correct side of the door to fit the handle (opposite the hinge).

2. Align the screw holes on the handle assembly with the holes in the door.

3. Using the Allen key, attach the handle assembly with the provided M4 screws:

a. Fit one screw finger-tight to the middle bracket ‘B’.

b. Fit one screw finger-tight to the top bracket ‘A’ and one to the bottom bracket ‘C’.

c. Ensure the handle is located correctly on the door.

d. Fit the remaining 3 screws and tighten all screws.

4. Ensure all screws are fully tightened.

5. Fit the Covers by clipping them onto the brackets.

Once the handle is securely attached to the door of your WESTINGHOUSE WRB5004S, the final step is to assemble the screw hole plugs:

1. Select the plugs of the correct colour (White or Grey) to match your refrigerator.

2. Push the plugs into the screw holes on the hinge side of the door (the side opposite the new handle).

Your handle installation is now complete.