V-TAC VT-44034 (01) PDF MANUAL

V-TAC VT-44034 (01) PDF SUMMARY:

What should I do if I have a query/issue with the product?

Reach out to support@v-tac.eu.

What should I do before starting the installation?

Please read these instructions carefully before starting the installation and keep this manual handy for future reference.

What are the installation instructions?

• Ensure electricity is switched off before installation.
• Do not use in areas with limited ventilation or outside the rated ambient temperature range.
• Connect with a waterproof cable house only.
• Please do not mount to a surface that is prone to vibrations.
• Remove the screw and the bracket afterward.
• Before drilling, mark the hole position for fixing the bracket onto the wall (screw not supplied).
• Screw the retaining bracket to the wall with a suitable quantity of screws.
• Mount the bracket back to the fixture. Adjust the floodlight according to the desired position. Tighten the screw.
• Connect your main cable (HO5RN-F3G1.0mm2 Recommended) with the input lead of our product through the waterproof junction box. Note, the line (-) of the lead. (Need to use the junction box of IP65 or above, ensure to tighten the waterproof screw).
• Switch on the power to make sure if the product is working.

What warnings should I be aware of?

• Please make sure to turn off the power before starting the installation.
• Installation must be performed by a qualified electrician.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• Replace any cracked protective shield.
• Terminal block not included.
• Proper grounding should be ensured throughout the installation.
• Minimum distance from lighted objects 1m.
• Limitation of use indoors and outdoor.

What is the note about flexible wiring?

To reduce the risk of strangulation, the flexible wiring connected to this luminaire shall be effectively fixed to the wall if the wiring is within arm’s reach.

What voids the warranty?

Light source removal will void the warranty. Usage of product for 24 Hours a day would void the warranty. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. This product is warranted for manufacturing defects only.

What are the remote control functions?

• On
• Off
• Increase Brightness
• Decrease Brightness
• 6500K
• Red
• Blue
• Green
• Red, Green & Blue alternating rapidly flashing
• Red, Green & Blue alternating slow flashing
• Red, Green & Blue Mixed alternating
• Red, Green & Blue Breathing state
• Multiple Color Options