SUPERMICRO SUPERSERVER SYS-E100-12T-L (01) PDF MANUAL

SUPERMICRO SUPERSERVER SYS-E100-12T-L (01) PDF SUMMARY:

What safety information is important before connecting the system to the power supply?

See installation instructions and safety warnings.

What warning should I heed to reduce the risk of electric shock/damage to the equipment?

To reduce risk of electric shock/damage to equipment, disconnect power from server by disconnecting all power cords from electrical outlets. If any CPU socket is empty, install a protective plastic CPU cap.

What should I ensure when using power supplies for the system?

Always be sure all power supplies for this system have the same power output. If mixed power supplies are installed, the system will not operate.

What does one beep code mean?

Circuits have been reset (Ready to power up).

What does 5 short beeps and 1 long beep code mean?

No memory detected in the system.

What does 5 long beeps and 2 short beeps code mean?

Video adapter missing or with faulty memory.

What does 1 long continuous beep code mean?

System overheat condition.

How do I remove the chassis cover?

1. Remove power from the system.
2. Remove the eight screws that hold the cover in place.
3. Lift the cover up and off the chassis.

How do I install the mounting brackets?

1. Turn the chassis over to the bottom side.
2. Decide whether the bracket mounting holes will face outwards or inwards.
3. Decide which screw holes will be used; the mounting bracket supports two screw alignments.
4. Align the screw holes on the mounting bracket with the screw holes on the chassis.
5. Install two screws.
6. Repeat on the other mounting bracket.