Free English SONY STR-AV1070X (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SONY STR-AV1070X (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the symptoms of the hissing noise issue in the rear surround channel on the SONY STR-AV1070X?
The symptom is described as a high frequency hiss present in the rear surround channel. This noise is most noticeable with the master volume turned up to at least 50%, the rear channel level at 0dB, and no signal source present.
What procedure should be followed to fix the hissing noise on the SONY STR-AV1070X?
If the hissing symptom occurs, perform the following steps:
1. Change resistors R342 and R343 from 330K to 220K.
2. Remove pot RV301 and replace it with a wire (short).
3. Remove the negative leads of caps C330 and C317 off the board and solder them together (off the board), then solder into them a wire from the Digital ground. Then connect the digital ground into the analog ground.
4. Change C390 from 0.22µF to 10µF.
5. Change C319 from 4.7µF to 1µF.
6. Change R346 from 100K to 10K.
What are the specific part numbers and value changes required for the SONY STR-AV1070X modification?
| REF. NO. | DESCRIPTION (FORMER) | DESCRIPTION (NEW) | PART NUMBER |
|---|---|---|---|
| R342 | 330K | 220K | 1-216-105-00 |
| R343 | 330K | 220K | 1-216-105-00 |
| C390 | 0.22µF | 10µF | 1-124-907-11 |
| C319 | 4.7µF | 1µF | 1-124-903-11 |
| R346 | 100K | 10K | 1-216-073-00 |
CLICK HERE TO DOWNLOAD SONY STR-AV1070X (01) PDF DOCUMENT