SMALLRIG POTATO JET TRIBEX SE (01) PDF Document

The package for the SMALLRIG POTATO JET TRIBEX SE includes the following items:

• 1 x Tripod

• 1 x Allen Wrench

• 1 x Smartphone Holder

• 1 x Carrying Bag

• 1 x Operating Instruction

The main components of the SMALLRIG POTATO JET TRIBEX SE tripod are identified as follows:

Video Head Components:

• Video Head

• Quick Release Plate

• QR Plate Safety Button

• QR Plate Locking Knob

• Safety Pin

• Female Screw for Accessories

• Built-in Allen Wrench

• Tilt Locking Knob

• Pan Locking Knob

• Pan Bar Locking Knob

• Detachable Pan Bar

• Bubble Level

Tripod Body Components:

• Leg Angle Lock

• X-Clutch Handle

• Center Column

• Hook

• Rubber Foot

To set up the SMALLRIG POTATO JET TRIBEX SE tripod, follow these steps:

Step 1. With the tripod standing upright, grip the X-Clutch Handle.

Step 2. Squeeze the X-Clutch Handle to release the legs.

Step 3. While squeezing the handle, allow the legs to spread outward and downward until they are fully extended and stable on the ground.

To fold the X-Clutch Handle for storage, rotate it 90 degrees so that it sits flush against the tripod’s center column assembly.

To configure the SMALLRIG POTATO JET TRIBEX SE for low-angle shooting, follow these steps:

Step 1. Loosen the screw at the bottom of the center column by two turns to remove the column from the tripod base.

Step 2. With the center column removed, the tripod legs can be spread out to their widest angle, allowing the video head to be positioned much closer to the ground.

The operating altitude for the SMALLRIG POTATO JET TRIBEX SE ranges from a minimum height to a maximum height, depending on the configuration:

• Low Angle Height: 25.0 cm / 9.8 in

• Minimum Height (legs collapsed): 72.0 cm / 28.3 in

• Maximum Height (legs extended, center column down): 138.0 cm / 54.3 in

• Maximum Height (legs extended, center column up): 166 cm / 65.3 in

Please follow these important notes when using your SMALLRIG POTATO JET TRIBEX SE:

1. Before shooting, make sure the head and tripod locking status are in normal condition.

2. Avoid use in sandy or dusty environments to prevent the risk of damage.

3. After using the short center column, mounted on the center column, need to ensure that the locking status.

4. Max payload of head: 6.0kg / 13.2lb (center column raised, leg angle at 22°, height at 166.0cm / 65.3in).

5. The weight capacity of the tripod head is not the absolute limit; it varies depending on the type of equipment, lenses used, accessories attached, and changes in the center of gravity.

6. Max payload of tripod: 15.0kg / 33lbs (center column not raised, tripod head detached, leg angle at 22°, height at 130.0cm / 51.2in).

7. After soaking in water, it needs to be dried before use.