ALLITY AWC-210-15WMS (01) PDF Document

Input voltage: USB-C: 5.0 V = 2.0 A (10.0 W), 9.0 V = 2.0 A (18.0 W)

Charging power: 15.0 W

Conversion efficiency: ≥75%

Inductive charging distance: ≤6mm

Cord length: 1m

Frequency range: 110 – 205kHz

Included in the set: Inductive charger, cord, manual

The ALLITY AWC-210-15WMS wireless charger enables charging of mobile devices without the need to connect them directly to a power supply via a cable. The wireless charger uses electromagnetic waves to transfer energy from the transmitter (charger) to the receiver (charging device), allowing devices to be charged wirelessly. Always use the device for its intended purpose. Using the device for purposes other than its intended use is illegal and harmful to the environment.

Remove the USB-C cable from its packaging. Connect one end of the USB-C Cable to the mains adapter, and the other end to the USB-C connector on the charger. Place the smartphone near the charging slot marked on the charger. The magnet will automatically snap into place and accurately position your smartphone in the most efficient slot for charging.

The device has an adjustable stand that allows the phone to be placed on a flat surface, such as a desk or table.

When charging is complete, remove the device from the charger.

The charger is designed primarily for use with iPhone with MagSafe technology. The charger can be used with other devices, but the magnetic function will not work.

Read the instructions carefully and keep them for future reference. Ignoring these instructions can be dangerous or illegal. Failure to do so may result in permanent damage or malfunction.

• A wireless charger is a device that allows electronic devices such as smartphones to be charged wirelessly. Use of the device beyond its intended purpose is illegal and harmful to the environment.

• Use the device only for its intended purpose.

• Do not use the product in areas where the use of electronic equipment is prohibited, or where it may cause interference or other hazards.

• The manufacturer is not responsible for damage caused by tampering. The same applies if other than the original wiring is used.

• Do not expose the unit to water or other liquids. The unit should not be used in areas of high humidity. This can adversely affect the operation and life of electronic components.

• The device should not be operated by persons (including children) with reduced mobility or mental capacity, or by persons who are inexperienced in the use of electronic equipment. They should only use it under the supervision of persons responsible for their safety.

• Do not use the device if it shows signs of damage or if you suspect that it is not working properly.

• Packaging can be recycled according to local regulations.

If the ALLITY AWC-210-15WMS charger fails to charge the device when connected, follow these steps:

• Check that the power source to which the charger is connected is not faulty.

• Check that the connection cable (USB-C) is not damaged.

• Check that the device whose battery is being charged is not damaged.

If the inductive charging is not working, check the following:

• Check that the maximum inductive charging distance has not been exceeded (e.g. by using additional cases on the device being charged).

• Check that the technical parameters of the power source used are compatible with those of the charger.

It is normal for the charger to heat up. Make sure that the device for which the battery is being charged is not using too much power. If the problem persists, contact your service provider.

Use only a soft, dry cloth to clean the device. Do not use strong acid or alkaline detergents.