SHURE MV7X (01) PDF DOCUMENT

The SHURE MV7X is a professional-quality dynamic microphone, ideal for close mic applications that require vocal intelligibility with a balanced tone. The attractive and durable all-metal design features an adjustable yoke that can be mounted onto a variety of microphone stands for flexible placement options.

Voice Isolation Technology

Its highly directional cardioid pattern isolates your voice and removes unwanted background noise.

Durable, Versatile Design

It features a rugged, all-metal construction and excellent cartridge protection for outstanding reliability.

The SHURE MV7X features a dynamic capsule with a cardioid pattern, which uses Voice Isolation Technology to pick up sound directly in front of the microphone.

The SHURE MV7X has a passive XLR output. You can connect it to XLR mixers and interfaces.

The SHURE MV7X microphone comes equipped with a 5/8″-27 threaded mount, which is the thread size most commonly found on microphone stands. This mount can be used with a microphone stand or hung from a boom. Note: Be very careful not to unloosen the screws all the way.

To easily flip the microphone orientation, loosen the screws and rotate it 180 degrees.

The windscreen on the SHURE MV7X offers maximum protection from plosives (puffs of air) and creates a warmer, more intimate sound for speech applications, like podcasting and gaming.

Transducer Type: Dynamic (moving coil)

Polar Pattern: Unidirectional (Cardioid)

Output Impedance: 252 Ω

Frequency Response: 20 Hz to 20,000 Hz

Sensitivity (@ 1 kHz, open circuit voltage): -55 dBV/Pa (1.78 mV)

Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3

Housing: All metal construction

Mounting Type: 5/8-27 thread mount

Net Weight: 0.55 kg (1.21 lbs)

Microphone Only:

Length: 153.6 mm (6.05 in)

Diameter: 66.5 mm (2.62 in)

Microphone in Yoke:

Height: 164.0 mm (6.46 in)

Length: 153.6 mm (6.05 in)

Depth: 90.2 mm (3.55 in)

If the microphone becomes detached from the yoke, these are the steps to put it together in the correct order to ensure that your microphone is secure. Each side uses one thin gray spring washer, one shiny silver brass washer, two black plastic washers and the yoke and threaded yoke knob.

1. Start with the threaded knob flat side down on your tabletop.

2. Stack the washers on the threaded knob.

– Place a black plastic washer on the knob.

– Place one side of the yoke on next.

– Then put the second black plastic washer on.

– Place the flat silver washer and then the thin spring washer on the threaded knob.

3. Using your finger to hold the screw assembly in place, slide the MV7X onto the threaded screw and turn the knob to keep washers in place.

Note: Be sure to keep this side on but loose so that you have room to easily move the yoke and assemble the washers on the opposite side.

4. On the opposite yoke arm, place the washers into the side of the MV7X in reverse order. Thin spring washer > Flat silver washer > Black plastic washer > Yoke arm

5. The yoke arm needs to be placed directly onto the stack of washers. To ensure that the washers are aligned, put a pen through the yoke and washers to make sure that everything is properly centered. Leave pen in place.

6. Place the second black plastic washer onto the remaining threaded knob.

7. Remove the pen. Insert the threaded knob and black plastic washer into the stacked washers and tighten both sides to ensure that your microphone is stable.