SHARK WANDVAC POWER PET WV400 (01) PDF DOCUMENT

If the charging cord plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT force it into the outlet or try to modify it to fit.

When using an electrical appliance, basic precautions should always be followed:

1. There are NO serviceable parts.

2. DO NOT use to vacuum any liquids.

3. DO NOT immerse in water or other liquids.

4. If the vacuum is damaged, discontinue use.

5. To avoid fire, explosion, or injury, inspect the vacuum and charging dock for any damage before use. DO NOT use a damaged vacuum or charging dock.

6. DO NOT use outdoors or on wet surfaces. Use only on dry surfaces.

7. If the vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors, or immersed in water, return it to SharkNinja Operating LLC for examination, repair, or adjustment.

8. DO NOT handle the charger or vacuum cleaner with wet hands.

9. DO NOT leave the vacuum cleaner unattended while powered on.

10. Keep the vacuum away from heated surfaces.

11. Always turn off the vacuum before connecting the charging dock.

12. Use only Shark® chargers and batteries. Other types of batteries may burst, causing injury and damage.

13. Use the charging dock on flat and stable surfaces only.

14. DO NOT incinerate the appliance, even if it is severely damaged, as the lithium-ion battery may explode in a fire.

15. Servicing can only be performed by a qualified repair person using only identical replacement parts.

16. DO NOT carry the charger by the cord or yank to disconnect from an outlet; instead, grasp the plug and pull to disconnect.

17. Keep the charger cord away from heated surfaces.

18. Use only as described in the manual.

19. Keep your work area well lit.

20. To avoid unintentional starting, always turn off the vacuum cleaner and remove the battery pack before picking it up or carrying it, and before attaching or detaching the charger, dust cup, filter, or any accessories.

21. DO NOT put any objects into openings.

22. DO NOT use if any opening is blocked; keep free of dust, lint, hair, or anything that may reduce airflow.

23. This vacuum is not a toy and must not be played with. Children over 8 years old and persons with reduced physical, sensory, or mental capabilities may only use the vacuum with supervision or prior safety instruction and an understanding of the hazards involved. Children may not clean or maintain the vacuum without supervision.

24. DO NOT use without the dust cup and filter in place.

25. DO NOT use if airflow is restricted; if the air paths become blocked, turn off the vacuum cleaner. Clear all obstructions and power on again.

26. Keep the nozzle away from hair, face, fingers, uncovered feet, or loose clothing.

27. Only use manufacturer’s recommended attachments.

Before turning on the vacuum:

31. Make sure the filter is thoroughly dry after routine cleaning.

32. Make sure the dust cup and filter are in place after routine maintenance.

33. Make sure accessories are free of blockages and keep openings away from your face and body.

34. Use only Shark® brand filters and accessories. Using other brands will void the warranty.

35. DO NOT vacuum up hard or sharp objects such as glass, nails, screws, or coins that could damage the vacuum cleaner.

36. DO NOT vacuum up drywall dust, fireplace ash, or embers.

37. DO NOT use as an attachment to power tools for dust collection.

38. DO NOT vacuum up smoking or burning objects such as hot coals, cigarette butts, or matches.

39. DO NOT vacuum up flammable or combustible materials (e.g., lighter fluid, gasoline, or kerosene) or use the vacuum in areas where they may be present.

40. DO NOT vacuum up toxic solutions (e.g., chlorine bleach, ammonia, or drain cleaner).

41. DO NOT use in an enclosed space where vapors are present from paint, paint thinner, moth-proofing substances, flammable dust, or other explosive or toxic materials.

42. DO NOT immerse the vacuum cleaner in water or other liquids.

43. Use extra care when cleaning on stairs.

44. The battery is the power source for the appliance. DO NOT carry the appliance with your finger on the power button. DO NOT charge the appliance with the power on.

45. Use only the included charging dock XDOCKCWV to charge. Use of an incorrect charger may create a risk of fire.

46. Use the appliance only with the included lithium-ion battery XSBT420. Use of any other battery may create a risk of injury and fire.

47. Under abusive conditions, liquid may be ejected from the battery. Avoid contact with liquid, as it may cause irritation or burns. If contact occurs, flush with water. If liquid contacts eyes, seek medical help.

48. Store the appliance indoors. To maintain battery life, DO NOT use or store the battery at temperatures below 37.4°F (3°C) or above 104°F (40°C).

49. DO NOT expose the battery pack to fire or temperatures above 266°F (130°C) as it may cause an explosion.

50. There are NO serviceable parts. To ensure safety, DO NOT modify or attempt to repair the battery pack.

51. DO NOT use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.

52. When the battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws, or other small metal objects. Shorting the battery terminals increases the risk of fire or burns.

53. Remove the battery pack from the vacuum before making any adjustments, changing accessories, or storing the appliance. This preventative safety measure reduces the risk of starting the appliance accidentally.

1. Slide the Onboard Accessory Storage Attachment onto the back of the Charging Dock until it clicks into place.

2. Route the cord through the grooves in the bottom of the charging dock and onboard accessory storage attachment, then through the slot in the back.

3. Slide the vacuum cleaner into the first opening on the charging dock and stand it up.

4. Slide the accessories into the openings on the onboard accessory storage attachment.

NOTE: To ensure the stability of the charging dock, be sure to attach the accessory storage attachment to the charging dock. Be sure to put accessories in the designated slots so the vacuum sits properly in the charging dock.

The following items are included:

A Charging Dock

B Handheld Vacuum

C Onboard Accessory Storage Attachment

D Duster Crevice Tool (WV401/WV403)

E Crevice Tool (WV410)

F Pet Tool (WV410)

G Motorized Hand Tool (WV403 only)

H Lithium-Ion Battery (pre-installed)

Prior to first use, charge the battery completely. A full charge takes approximately 3.5 hours. The maximum operating time in ECO mode with one fully charged battery is 35 minutes.

There are two types of indicators depending on your model.

For models with a single light ring:

In Use: Solid blue.

Low Battery: Blinking.

Charging: Fades in and out.

Charged: Dim.

For WV403 models with three LED indicator lights:

In Use:

Three solid lights: Full Charge

Two solid lights: Mid Charge

One solid light: Low Charge

One blinking light: Nearly Empty or No Charge

Charging:

One blinking light: No Charge

One solid, one blinking light: Mid Charge

Two solid, one blinking light: Nearly Full

Three solid lights: Full Charge

Plug the charging dock into a wall outlet. Charge the vacuum by sliding it into the charging dock nozzle-first. Make sure the contacts on the vacuum are aligned with the contacts on the charging dock.

When docked properly, the charging lights on the hand vacuum will blink, indicating that charging has begun. When charging is complete, the indicator lights will remain on for 5 minutes, then shut off. For maximum runtime, charge fully before first use (approximately 3.5 hours). Leaving the unit plugged in will not damage battery life.

To remove the battery from the hand vacuum, press the release tabs on the battery cap and slide out the battery. To reinstall, slide the battery into the compartment in the handle until it clicks into place.

Deep Clean Mode: Press the On/Off button on the handle to go into Deep Clean mode. Press the power button again to turn off the vacuum.

Boost Mode: For an added boost of power, press the Boost button. Press again to return to Deep Clean mode.

ECO Mode (WV403 Only): Press the ECO button for noise reduction. Press again to return to Deep Clean mode.

To attach an accessory to the hand vacuum, slide it into the opening in the nozzle. To remove the accessory, slide it off the nozzle.

If your vacuum has One-Touch Accessory Release buttons, press the One-Touch Accessory Release buttons on either side of the handle to release an accessory from the hand vacuum.

1. With the power off and the hand vacuum positioned over a trash receptacle, slide the Dust Cup release button near the handle, and the dust cup will drop open. Tap the filter screen lightly to knock off dust and debris.

2. Wipe the screen inside the dust cup lightly with a dry cloth to remove dust and dirt.

1. With the dust cup removed and the power off, pinch both sides of the filter housing and pivot it upward to access the filter.

2. Hold the filter housing over a trash receptacle. Lift the fabric filter by the metal ring to remove it from the housing. Tap lightly to remove any dust and debris, then rinse with water only. Let the filter air-dry for at least 24 hours or until completely dry before reinstalling.

If you vacuum up a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught in the vacuum.

1. Turn off the vacuum.

2. Check all intake openings to the dust cup and remove any debris or blockages.

If the vacuum is not picking up debris, has no suction or light suction, and the power button blinks white six times in 2-second intervals, you should check the filters to see if they need cleaning. Follow the instructions for rinsing and completely air-drying the filters before reinstalling them. Also, refer to the “Checking for Blockages” section for more information.

There are several possible reasons for the vacuum turning off on its own, including blockages, battery issues, and overheating. If your vacuum turns off on its own, perform the following steps:

1. Turn on the power and check the battery indicator lights on the vacuum. If recharging is needed, make sure vacuum power is off before charging.

2. Empty the dust cup and clean the filters.

3. Check accessories and inlet openings and remove any blockages.

4. Allow the unit and battery to cool for at least 45 minutes, until they return to room temperature.

5. Press the On/Off button to restart the vacuum.

The following accessories are available:

A Duster Crevice Tool

B Motorized Hand Tool (Only for the WV403)

C Upholstery Tool

D Wide Upholstery Tool

E Replacement Battery

F Pet Tool

G Battery Charging Sleeve