RYOBI GDA100 (01) PDF Document

The RYOBI GDA100 remote control activates the garage door opener from a distance of up to 300 ft. It is equipped with a visor clip for convenient storage.

The remote can be powered by one 2032-size battery or two stacked 2016-size batteries. Two 2016-size batteries are pre-installed in the remote.

Follow these steps to program your RYOBI GDA100 remote control:

1. Press the Program button on the garage door opener’s console.

2. The main garage door opener unit’s LEDs will turn off and the Program button will flash three times.

3. Select button 1 or 2 on the car remote. Press the button once.

4. The car remote’s green LED will flash.

5. The Program button on the main unit will flash three times.

6. The garage door opener main unit LEDs will turn on.

7. To verify that the program is set, press the car remote button you selected earlier.

8. The garage door will open or close.

Repeat this process to sync the garage door opener with an additional remote.

NOTE: Buttons 1 and 2 cannot both be programmed to the same garage door opener.

NOTE: Safety sensors must always be connected properly for the door to operate from the car remote.

To replace the batteries in your RYOBI GDA100, follow these steps:

1. Remove the battery cover by inserting the edge of a coin into the slot and twisting.

2. Install the battery or batteries according to the polarity indicators.

3. Reassemble the remote by aligning the sections as shown.

4. Snap the sections together to close.

5. Make sure the remote is securely reassembled before attaching the visor clip.

WARNING: KEEP BUTTON/COIN CELL BATTERIES OUT OF SIGHT AND REACH OF CHILDREN. Swallowing batteries can lead to serious injury or death. If you suspect a child has ingested a battery, go to the hospital immediately. Do not induce vomiting or have your child eat or drink anything.

WARNING: Risk of injury due to fire, explosion, or leakage. Do not disassemble, charge, crush, or expose to fire or high temperatures.

To reduce the risk of injury, do not attempt to use this product until you have read thoroughly and understand completely this operator’s manual and the operator’s manual for the GD200 garage door opener. Ensure compatibility and fit before using this accessory. Do not use this accessory if a part is damaged or missing.

WARNINGS:

• Keep moving door in sight. Contact with moving door can cause DEATH or serious injury.

• To avoid accidental use place keypads and remotes in a location that is inaccessible to children.

• Do not use garage door opener if keypads or remotes do not start and stop the motor. An opener that cannot be controlled with a keypad or remote is dangerous, can result in death or serious personal injury, and must be repaired.

• Inspect before every use; do not use if parts are loose or damaged.

• Always wear eye protection with side shields marked to comply with ANSI Z87.1.

• Keep out of the reach of children.

• Use only as intended.

• Keep the remote clean and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any strong solvents to clean the remote. Following this rule will reduce the risk of loss of control and deterioration of the enclosure plastic.

• Save these instructions. Refer to them frequently and use them to instruct others who may use this product. If you loan someone this product, loan them these instructions also to prevent misuse of the product and possible injury.

The signal words and symbols are intended to explain the levels of risk associated with the RYOBI GDA100.

Signal Words

• DANGER: Indicates a hazardous situation, which, if not avoided, will result in death or serious injury.

• WARNING: Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.

• CAUTION: Indicates a hazardous situation, that, if not avoided, may result in minor or moderate injury.

• NOTICE: (Without Safety Alert Symbol) Indicates information considered important, but not related to a potential injury (e.g. messages relating to property damage).

Symbols

• Safety Alert: Indicates a potential personal injury hazard.

• Read Operator’s Manual: To reduce the risk of injury, user must read and understand operator’s manual before using this product.

• Moving Door: To avoid death or serious personal injury, stay clear of the garage door while it is moving and never attempt to run or walk under moving garage door.