RTS DIGITAL MATRIX ZEUS II (01) PDF Document

The RTS DIGITAL MATRIX ZEUS II has the following additional features:

• There are two power supplies and therefore two cord connections on the rear of the unit.

• Simply plug the power cords to turn the unit ON.

• There are two additional LEDs (PS1 & 2) on the front panel which indicate the status of the power supplies.

• There is an additional connector (J28) which is used along with an RS-232 to RS-485 converter (not supplied) for trunking.

To turn on the RTS DIGITAL MATRIX ZEUS II, simply plug the power cords into the 90-250 VAC inputs on the rear of the unit.

To set up the Zeus Edit software for trunking on your RTS DIGITAL MATRIX ZEUS II, follow these steps:

Step 1

1. Select Intercom Configurations located under the |Options| menu.

2. Click on the Options tab.

3. Make sure there is an X mark next to the “Allow for remote trunk master” entry.

4. Click on Apply.

Step 2

1. Select Preferences located under the |Options| menu.

2. Click on the Advanced tab.

3. Make sure there is an X mark next to the “Enable trunking support” entry.

4. Click on OK.

The RTS DIGITAL MATRIX ZEUS II communicates at 9600 baud with the Trunk Master (TM-2000). Be sure to configure the communications in the Trunk Edit software for 9600 baud.