RAKO RML-1200 (02) PDF MANUAL

RAKO RML-1200 (02) PDF SUMMARY:

What is the RML-1200?

Rako RML-1200 modules are digital leading edge dimmers suitable for use with mains voltage tungsten lighting and low voltage tungsten with leading edge dimmable transformers.

Are RML1200s recommended for use with mains dimmable LEDs?

No. RML1200s are inductive dimmers, and are not generally recommended for use with mains dimmable LEDs.

What are the loading specifications for the RML-1200?

• Minimum: 20W
• Maximum: 1200W
• Low-voltage transformer loads (leading edge only): 1080W (de-rate by 10%)
• Mains voltage LEDs: Not Recommended

Where should RML1200 modules be mounted?

RML1200 modules should be mounted in areas that are:

• Adequately ventilated
• Dry
• Outside of any metal enclosed casings that may interfere with the wireless signal

How should modules be mounted?

Modules should be mounted vertically, with the terminals at the bottom.

What should be done with cable clamps on the supply and load cables?

Ensure that cable clamps are securely fitted on the supply and load cables.

Where should modules be mounted in regards to maintenance?

While the modules are designed to be completely maintenance free, they should be mounted in an accessible location should investigation or re-addressing of the units be necessary.

How do you remove the cover on the RML-1200?

1. Remove the two screws at the bottom of the unit.
2. Pulling the bottom of the cover away from the bottom.
3. Lifting it up.

How do you insert the supply IN conductors and the load OUT conductors?

Insert the supply IN conductors as well as the load OUT conductors.

How do you fit the cable clamps?

Fit the supplied cable clamps and ensure the cable is unable to move.

How do you replace the cover?

Replace the cover and replace the screws.

What should happen when power is initially connected to the module?

The load should power up to full brightness.

What can the clear button be used for?

The clear button can be used as a manual on/off switch to test the circuit.

What does it mean when the internal LED behind the clear button flickers?

The internal LED behind the clear button will flicker when the module receives ANY Rako wireless message and is a useful diagnostic indicator.

How long does the internal LED flicker for?

This function becomes inactive after 20 minutes to avoid a nuisance light spill.

How can you reactivate the internal LED?

It can be re-activated by pressing the clear button.

What should be done if the module does not respond to any of the above?

Should the module not respond to any of the above, further investigation must be made before proceeding any further.

When is the RML-1200 ready to be programmed?

Once the RML-1200 has powered up and has been tested working with the setup button, the device is ready to be programmed.

Where can I find instructions on how to program the RML-1200?

For instructions on how to program the RML-1200, see the Wireless Module Setup Guide.

What does it mean when the LED has good wireless reception?

When the unit is receiving successfully, there will be four rapid pulses on the LED when any wireless message is sent.

What does it mean when the LED has bad wireless reception?

When the unit is out of range, there will be intermittent pulses on the LED when any wireless message is sent.

What is recommended if you are experiencing intermittent wireless range?

It is recommended to install a wireless repeater (WRB-100) if you are experiencing intermittent wireless range.