PETLIBRO AIR PLAF108 (01) PDF Document

Please adhere to the following safety instructions when using the PETLIBRO AIR PLAF108:

• Use the feeder in a dry place.

• Use the feeder on a level surface.

• Dispose of all packaging materials properly. Some items may be packed in plastic bags; these bags could cause suffocation.

• Keep them away from children and pets.

• Do not use the feeder with pets that are not able to reach the food bowl or with any physical disability.

• Do not immerse the base part in water at any time as it may damage electronic components.

• Do not use the feeder outdoors. Check its operation frequently to be sure it is operating properly.

• Do not disassemble the feeder other than as instructed in this user manual.

• Only use accessories recommended or sold by the manufacturer. The use of accessories not recommended or sold by the manufacturer may cause an unsafe condition.

• Do not modify the feeder.

• Examine the feeder after installation. Do not plug in if there is water on the power cable or plug.

• To avoid tripping, always position the power cable out of the way of foot traffic.

• Do not install or store the feeder where it will be exposed to weather or temperatures below 0°C (32°F).

• Do not use the feeder without adding pet food first.

• Power off the feeder when it’s not in use.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• The appliance is only to be used with the power supply unit provided with the appliance.

• If the cord set is damaged, it must be replaced by a special cord set available from the manufacturer or its service agent.

The PETLIBRO AIR PLAF108 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The PETLIBRO AIR PLAF108 is considered waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) and should not be mixed with unsorted household waste. To protect human health and the environment, you should hand over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.

The PETLIBRO AIR PLAF108 should only be used with the power supply unit provided with the appliance. The compatible model numbers are:

US: TPA-46B050100UU, TPA-418G050100CU01

EU: TPA-147K050100VU01, TPA-67B050100VU01, TPA-46050100VU, TPA-418K050100VU01

UK: TPA-38A050100BU01, TPA-418B050100BU01

JP: TPA-95A050100UU01, TPA-98B050100PU01, TPA-418G050100PU01

AU: TPA-418K050100SU01, TPA-147C050100SU01

• 1 x Automatic Pet Feeder

• 1 x Stainless Steel Bowl

• 1 x Bowl Tray

• 1 x Quick Start Guide

• 1 x User Manual

• 1 x Power Adapter

• 1 x Power Cable

1. Lid Release Button

2. Lid

3. Food Tank

4. Tank Base

5. Rotor

6. Indicator

7. Food Tank Lock

8. Food Outlet

9. Stainless Steel Bowl

10. Bowl Tray

11. Power Cable Slot

12. USB-C Power Port

13. Reset Button

14. Power Switch

15. Non-slip Rubber Pad

1. Remove the food tank cover and take out the accessories.

2. Connect the power cable. (You can use the feeder wirelessly after fully charging its battery.)

3. Toggle the power switch on the bottom of the feeder to “ON” to turn on the feeder.

1. Press the lid release button and remove the lid.

2. Add dry pet food to the food tank.

3. Replace the lid and press the lid release button to secure it.

4. Install the stainless steel bowl and bowl tray.

1. Scan the QR code in the user manual or search in your device’s app store to download and install the PETLIBRO app.

2. Follow the instructions within the app to configure the network and connect your feeder.

To power off the feeder, toggle the power switch on the bottom of the unit to the “OFF” position.

1. Pull the food tank locks outwards.

2. Lift the food tank cover off the base.

3. Hold the tank base, turn the rotor clockwise, and lift the rotor out.

4. Clean and air-dry the rotor, food bowl, and the food tank cover.

• Power off the device before cleaning.

• Clean the food bowl with tap water.

• Do not clean the feeder in a dishwasher. Only the stainless steel bowl is dishwasher safe.

• Use a soft damp cloth to clean the feeder base. Do not wash any part with electronic components.