NOTHING CMF WATCH PRO 2 D398 (01) PDF DOCUMENT

Scan the QR code provided or search for CMF Watch in the Google Play Store (for Android) or the App Store (for iOS) and download the application.

The main components of the watch are:

Front:

Function Button

Display Screen

Back:

Heart rate and blood oxygen monitoring sensor

Speaker

Charging contact

Microphone

For the best heart rate measurement results, wear the watch a 1-2 finger width distance from your wrist bone. Fasten it comfortably and not too tight.

The watch and strap are made of materials that are safe to wear on skin. If you experience skin discomfort while wearing the watch, stop wearing it and consult a doctor or specialist.

1. Press your index finger and thumb on both sides of the bezel or press your palm against the entire bezel. Rotate it counterclockwise at an angle (about 20 degrees) with a little force until it can no longer rotate.

2. Pinch up vertically with two fingers to remove the bezel accessory.

1. Pick up the bezel and align the marking point on the inside of the bezel with the marking point at 12 o’clock on the screen of the watch body. The CMF by Nothing logo should be at 7 o’clock on the screen of the watch body. Lower it horizontally and fasten it to the watch body.

2. Press your index finger and thumb on both sides of the bezel or press your palm against the entire bezel. Rotate it clockwise with a little force until there is an obvious snap/click into place.

1. When disassembling the bezel accessories counterclockwise, avoid applying too much force to prevent damage to the internal structure.

2. When installing the bezel accessories clockwise, ensure that the bezel is horizontally snapped onto the watch body before rotating it to prevent damage to the internal structure.

3. It is not recommended to wear the watch without the bezel accessories attached, as this may scratch the skin or wear down the internal structure.

4. The identification mark on the back of the bezel must be aligned with the mark at the 12 o’clock position of the watch screen, and the CMF by Nothing logo should be placed at approximately 7 o’clock before tightening it by rotating clockwise.

5. Frequent disassembly and assembly of the bezel accessories can cause wear and tear to the internal structure, leading to failure to tighten or loosen, which is a normal phenomenon. Ensure a reasonable frequency of disassembling and assembling to extend the lifespan of bezel accessories.

To remove and replace a strap, turn the watch over and find the quick-release lever. There is one on each end where the strap meets the frame. Slide the quick-release lever and hold it to remove a strap from the watch or attach a new strap to the watch.

To enter pairing mode, press and hold the function button on the side to power on the watch. Then, in the CMF Watch app, tap the plus icon to add a device. Select the watch from the list of nearby devices, or scan the QR code displayed on the watch screen to pair.

Swipe down to expand Quick Settings.

Swipe up to see notifications.

Swipe left to see widgets.

Swipe right to see widgets or return to the previous page.

Press and hold the watch face to change it.

Cover the watch with your palm to turn off the screen.

Rotate Crown Up: Scroll up or go to the previous interface.

Rotate Crown Down: Scroll down or go to the next interface.

Press Button Once:

Wake the watch.

Open the feature list.

Pause or resume a workout.

Go back to the previous page.

Press and Hold Button:

Power on, power off, or restart.

Press for 10 seconds to force a restart.

To charge the watch, place it on the charging base. Ensure that both metal pads on the back of the watch are aligned with the metal tips on the charging line. Before charging, please wipe away any sweat or moisture residue to keep the charging contacts of the watch clean.

Gesture Control is turned off by default. To turn it on, connect the watch to the CMF Watch app. After connecting, enter the Gesture Control function within the app to turn it on and set the related options.