NICEBOY HIVE PODS 4 (01) PDF Document

The NICEBOY HIVE PODS 4 package contains the following items:

– NICEBOY HIVE PODS 4 headphones

– Charging box

– Backup earphone attachment

– USB-C cable

– Manual

The components are identified as follows:

1. Multifunctional button

2. LED diode

3. Charger input (charging pins)

4. LED charging indicator

5. Charging USB-C port

Follow these steps to pair your NICEBOY HIVE PODS 4 for the first time:

1. Take both headphones out of the charging box and remove the labels protecting the charging pins on the headphones.

2. Power on the headphones by long-pressing the multifunctional button on both headphones.

3. Once the LED diode begins to flash both green and red, the headphones are ready to connect to a Bluetooth device.

4. Open the Bluetooth settings on your device and search for “NICEBOY HIVE PODS 4” in the list of available devices.

5. A successful pairing will be announced by an audible queue, and the LED diode will flash green for a long interval.

To connect the NICEBOY HIVE PODS 4 to a device they have been previously paired with, simply take the headphones out of the charging box. They will automatically power on and connect to the device.

Powering On:

Simply take the headphones out of the charging box to power them on automatically, or manually power them on with a long press of both multifunctional buttons.

Powering Off:

To power the headphones off, place them back in their charging box. They will power off and disconnect from your device. The LED diode will turn red when the headphones are stored correctly. If the headphones are 100% charged, the diode will stop shining. You can also power off the headphones manually by a long press of both multifunctional buttons for about 6 seconds.

The multifunctional button on the NICEBOY HIVE PODS 4 has the following controls:

One press of either button: Play / pause, answer / end call

Press the right button twice: Increase the volume by one level

Press the left button twice: Decrease the volume by one level

Long press of right button: Next track, reject call

Long press of left button: Previous track, reject call

To charge the charging box itself, connect the charging cable to the USB port (5). The LED charging indicator (4) will flash during charging and will stop flashing once the battery is fully charged.

To restore the NICEBOY HIVE PODS 4 to their factory settings, place both headphones in the charging box. Then, hold down both of their multifunctional buttons until the LED diode flashes red three times. Once you take the headphones out of the box, they will be restored to their factory settings.

*The product is waterproof but not waterproof. The resistance to spills, water and dust is not permanent and may decrease over time due to normal wear and tear.

Listening to music at excessive volume can damage your hearing. Do not subject the equipment to fluids and moisture. Do not expose the device to excessively high/low temperatures, and do not attempt to disassemble it. Protect the device from sharp objects and falls from height.