NADY AUDIO RMX 6 (01) PDF Document

The NADY AUDIO RMX 6 includes the following features:

6-channel mic/line mixer in a single rack space (1U)

Balanced XLR mic and 1/4” TRS Line inputs on each channel

Master volume and bass, treble controls

Phantom power (15V) on channels 4-6 mic inputs

Dual (low and high level) outputs

Internal shielded power supply, ~115V/60Hz AC powered

The NADY AUDIO RMX 6 fits into one standard 19″ rack unit of space (1 3/4″). Parts of the unit can become very warm during use, which is normal. Ensure there is enough space around the unit for cooling (at least 12” or 30cm). Do not place the unit on high temperature devices such as power amplifiers, as it may overheat. Additionally, do not place the unit on speakers to prevent movement or falling due to vibration.

The unit has an internal power supply designed for external AC sources. Before connecting, confirm that the voltage selector switch on the back panel is set correctly for your area (120VAC/60 Hz or 230VAC/50Hz). Plug the AC cord into the power source only when ready to operate. Ensure the unit is turned off before connecting to the AC power to avoid loud transients that could damage speakers or hearing.

The power supply cord should be undamaged and should never share an outlet or extension cord with other devices if it exceeds the power rating. It should never be left plugged into the outlet when not being used for a long period of time.

Use the power switch on the front panel to turn the unit ON or OFF. An integrated LED will light when the unit is ON. Before turning on the unit, verify the connection to the proper voltage AC source, check all connections, and turn down the level controls of equipment connected to the outputs.

The Bass and Treble Tone Controls allow you to adjust the relative balance of bass and treble frequencies.

The Master Level Control adjusts the master level of the combined individual channel signals.

Use the Channel Gain Controls (1-6) on the front panel to adjust the individual channel gains.

The AC power cord IEC connector features a built-in fuse holder for a 5X20mm, 0.5A/250V slow-blow fuse. If the fuse continuously blows, shut off the unit and have it serviced by qualified service personnel.

Before plugging in the power cord, check that the unit is set for the proper voltage for your area: ~115V (60Hz) or ~230V (50Hz). Using the unit at the improper voltage can damage it.

This switch selects either high or low output so the level can be optimized for the connected audio equipment, such as an amplifier or recording device.

The unit features unbalanced 1/4″ (6.3mm) and balanced XLR outputs. Only one output (1/4″ or XLR) can be used at one time. Do not connect to both at the same time, or the signal will be severely distorted.

Channels 1 through 6 feature unbalanced 1/4″ (6.3mm) and balanced XLR inputs. Only one input per each channel (1/4″ or XLR) can be used at one time. Do not connect to both at the same time to avoid severe distortion.

Yes, channels 4, 5, and 6 provide +15V phantom power for condenser mics. These can be safely used with any balanced dynamic mic as well. However, do not connect any unbalanced dynamic microphones to the XLR balanced inputs on these channels as they may be damaged.