MIELE DA 390-6 (01) PDF Document

Press the On/Off button on the control panel to turn on the fan of your MIELE DA 390-6. The fan will start at power level 2.

Use the minus button to select a lower power level or the plus button to select a higher power level for your MIELE DA 390-6.

The IS level on the MIELE DA 390-6 is an intensive setting intended for strong vapors and odors that are temporarily produced when cooking, such as during searing.

Press the On/Off button on your MIELE DA 390-6 to turn the fan off.

The cooktop lighting on the MIELE DA 390-6 can be turned on or off separately from the fan by pressing the lighting button.

Yes, if the fan on the MIELE DA 390-6 is left on, it will automatically switch off after 10 hours. The lighting will remain on.

To program the intensive level to switch back to level 3 after 10 minutes on the MIELE DA 390-6, first turn off the fan and lighting. Press the minus and plus buttons at the same time for about 10 seconds until the number 1 lights up. Then press the lighting button, the minus button, and the lighting button again in that order. Use the plus button to activate the setting, and confirm by pressing the On/Off button.

Clean all stainless steel surfaces and control buttons of the MIELE DA 390-6 using only warm water and liquid dish soap, applying the mixture with a sponge cloth. Ensure no water gets into the interior of the hood. Dry the surfaces afterward with a soft cloth.

When cleaning the MIELE DA 390-6, avoid using cleaners containing soda, acid, or chloride, or those containing solvents. Also, avoid abrasive cleaners such as scouring powder, scouring liquid, or abrasive sponges.

For the MIELE DA 390-6, it is recommended to clean the grease filters once every 3 to 4 weeks.

To remove a grease filter on the MIELE DA 390-6, release the locking clip, open the filter to a 45 degree angle, unhook it, and remove it from the hood.

Yes, clean the filters of the MIELE DA 390-6 using a soft nylon brush in a mild solution of hot water and liquid dish soap. Do not use undiluted dish soap.

Yes, place the MIELE DA 390-6 filters upright or inclined as possible in the lower basket of the dishwasher. Ensure the spray arm is not obstructed. Use a common household dishwasher detergent and select a program with a temperature between 122 degrees F (50 degrees C) and 149 degrees F (65 degrees C).

Reinstall the grease filters on the MIELE DA 390-6 by making sure the locking clip is facing down.

First remove the grease filters from the MIELE DA 390-6. Remove the OdorFree Charcoal Filter from its packaging and press it into the frame. Then, reinstall the grease filters.

Always replace the OdorFree Charcoal Filter in the MIELE DA 390-6 whenever it no longer absorbs kitchen odors effectively. You should replace it at least once every 6 months.

Allow the MIELE DA 390-6 halogen lights to cool down completely. Press the lamp cover gently upwards so it opens and can be lowered. Pull the halogen lamp out of its socket.

The replacement halogen lamp for the MIELE DA 390-6 should be 12 V, 20 W, G4. Wear a glove or use a soft cloth to hold it while pushing it into the socket.

The minimum distance S depends on the appliance type: Electric/Induction cooktops require 24 inches (610 mm). Electric grill or deep fat fryers require 26 inches (660 mm). Multi-burner gas cooktops up to 43,000 BTU/hr require 26 inches (660 mm) for Miele or 30 inches (760 mm) for non-Miele. Multi-burner gas cooktops up to 73,800 BTU/hr require 30 inches (760 mm). Single-burner gas cooktops up to 20,500 BTU/hr require 26 inches (660 mm) for Miele or 30 inches (760 mm) for non-Miele. Single-burner gas cooktops up to 27,600 BTU/hr require 30 inches (760 mm). Some high-output cooktops are not permitted for installation under the MIELE DA 390-6.

The protective film on the MIELE DA 390-6 housing components can be peeled off easily without any additional tools before installing the components.

For vented mode operation of the MIELE DA 390-6, insert the non-return flap in the exhaust socket if your existing ducting system is not already equipped with one.

No, the MIELE DA 390-6 does not require the non-return flap for recirculation mode. If it is present, it should be removed.

The MIELE DA 390-6 must be hard wired as follows: connect the Black/Red wire to L1 (live), the White wire to N (neutral), and the Green wire to GND (ground).

When installing the exhaust duct horizontally for the MIELE DA 390-6, you must slope it away from the source by at least 1 cm per meter (3/8 inch per 3 1/4 feet) to ensure condensate does not drain back into the unit.

The diameter of the exhaust duct for the MIELE DA 390-6 should not be less than 6 inches (150 mm).

Yes, for the MIELE DA 390-6, it is recommended to install a condensate trap to collect and evaporate any accumulated condensate. Ensure it is positioned vertically and, if possible, directly above the hood outlet duct collar.

The data plate of the MIELE DA 390-6 is visible once you have removed the grease filters.

The following table lists the technical data for the MIELE DA 390-6:

Hang the MIELE DA 390-6 installation frame on the four screws (the front is marked with a V), align it, and secure it. Spacers can be used to align the hood vertically.

Holding the MIELE DA 390-6 installation frame securely, remove the two fixing screws, extend the frame to its maximum length, and then replace the screws.

For the MIELE DA 390-6 in recirculation mode, bend the four retaining tabs on the installation frame outwards, fit the directional unit while noting the marking on the front, and bend the retaining tabs back and approximately 45 degrees inwards to hold it in place.

Push the telescopic chimney over the MIELE DA 390-6 installation frame. For vented mode, ensure the recirculation grilles are at the bottom; for recirculation mode, ensure they are at the top. Bend the two retaining tabs outwards to prevent the chimney from slipping down.

Hang the MIELE DA 390-6 canopy on the chimney by pushing it up into the installation frame and pressing the retaining clips into the openings, ensuring the controls are at the front. Then, secure it using the supplied screws.

Unscrew the two screws from the MIELE DA 390-6 installation frame. Adjust the canopy height, following the marked limits (A for vented mode, U for recirculation mode), and secure it again with the screws.

The spacer frame on the MIELE DA 390-6 creates a shadow between the chimney and the ceiling, giving the illusion of a gap, which is helpful if the ceiling is uneven.

Yes, do not leave dirt and debris on the MIELE DA 390-6 control buttons, as they may become discolored or damaged. Remove debris immediately using the general cleaning instructions. Do not use a stainless steel cleaner on the control buttons.

If the MIELE DA 390-6 grease filters have been installed incorrectly, you can insert a small screwdriver into the slit to disengage the locking clip.

If the exhaust duct of the MIELE DA 390-6 is routed through rooms with varying temperatures, the duct will need to be insulated to prevent condensation issues.

To safely operate the MIELE DA 390-6, it must only be used for extracting cooking vapors, never for hazardous materials, and always with the grease filters in place.

Yes, never use an open flame beneath the MIELE DA 390-6. Do not flambé or grill over an open flame, as the hood will draw flames into the filter, potentially igniting grease.

If a grease fire occurs, smother flames with a close fitting lid, cookie sheet, or metal tray and turn off the burner. Do not pick up the flaming pan and do not use water.

Before cleaning or servicing the MIELE DA 390-6, always disconnect it from the electrical supply.

No, never use a steam cleaner to clean the MIELE DA 390-6, as steam can reach the electrical components and cause a short circuit.

The cardboard box and packing materials for the MIELE DA 390-6 are biodegradable and recyclable. Ensure plastic wrappings are disposed of safely and kept out of the reach of children to prevent suffocation.

When disposing of an old MIELE DA 390-6, unplug it, cut off the power cord, and remove any doors or parts to prevent danger to children. Do not dispose of it with household waste; contact your local recycling authority.

When using the MIELE DA 390-6 over a gas cooktop, ensure all burners are covered by cookware, adjust the flame so it does not extend up the sides of the cookware, and avoid overheating. Always turn on the hood whenever a burner is in use to prevent damage from condensation.

Do not touch the housing or grease filters of the MIELE DA 390-6 until the hood has cooled down after cooking.

Safety regulations prohibit the installation of the MIELE DA 390-6 above solid fuel stoves.

Only use metal ductwork with the MIELE DA 390-6 to reduce the risk of fire.

No, do not use the MIELE DA 390-6 with any solid-state speed control device.

No, the MIELE DA 390-6 is not intended for outdoor use.

If there is any doubt regarding the proper installation and grounding of the MIELE DA 390-6, have the electrical system of the house checked by a qualified electrician.

Before connecting the MIELE DA 390-6, make sure that the voltage and frequency on the data plate correspond to the building’s power supply.

No, do not use a power bar or extension cord to connect the MIELE DA 390-6 to electricity, as it is a fire hazard.

The MIELE DA 390-6 is completely isolated if the circuit breakers are tripped, the screw-type fuses are removed, or the power cable is unplugged from the socket.

Wear gloves when installing the MIELE DA 390-6 to protect your hands from sharp metal edges.

The MIELE DA 390-6 should be positioned centrally over the cooktop for optimal vapor extraction.

The MIELE DA 390-6 must be attached to rigid structural framing that is supported in its entirety by the ceiling joists, or to the ceiling joists directly. Do not attach the plate directly to the ceiling with anchors or toggle bolts.

In vented mode on the MIELE DA 390-6, the air is drawn in, cleaned by the grease filters, and directed outside.

In recirculation mode on the MIELE DA 390-6, the air is drawn in, cleaned by the grease filters, and then cleaned by an OdorFree Charcoal Filter before being recirculated back into the kitchen.