MIDEA MVC-C1211S-RD (01) PDF Document

For the first operation, it is advisable to read the manual carefully beforehand and keep it properly for future use. Before the first operation, make sure the dust cup or the dust bag is properly installed. Make sure the power supply is 220-240V~ 50/60Hz. Do not vacuum water, inflammable material, burning material, or ashes. Do not use the machine without a motor protection filter filled. Please change the dust bag immediately when it is damaged. Do not store or use the machine close to high-temperature places. Do not let children use the machine in case of danger. If abnormal noise, smell, smoke, or any other failure or breakage is found during the operation, you should turn off the switch and unplug it. Then contact with your service center for repair. Do not repair by yourself. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

To connect the hose accessories, insert the hose end into the hose socket at the front cover and then hook it. To remove the hose accessories, press the adaptors at both sides of the hose end and then pull the hose accessories.

Connect the plastic tube to the curved end of the hose. Connect different nozzle tools to the tube for different cleaning purposes: use the floor brush (adjust to the type of ground) for carpet or floor, and use the combine brush and nozzle for sofa, wall surface, curtain, corner, or space between furniture, etc.

To turn on the machine, insert the plug of the cord into the power socket which conforms to that on the label for power supply, and press the on/off switch pedal, the machine could start working. For cord rewinding, hold the plug and pull out the cord, then press the cord rewinding pedal, and that power cord will be drawn in.

To maintain the suction power of the vacuum cleaner, please clean the dust regularly. When the wind indicator turns to be red or loss of suction is noticed, it is time to empty the dust bag. Please wash the bag or replace it with a new bag if the bag is damaged. Open the front cover by pressing the front cover locker, take out the bag, and then empty it.

For the outlet filter, clip down and remove the outlet cover by hands for exchange of the filter. The motor protection filter should be cleaned or exchanged after it is dirty.

In case of malfunction, please refer to the following table:

If the problem still cannot be solved, please contact the local service center.