MARTA MT-1436 (01) PDF Document

The MARTA MT-1436 includes the following features and parts:

1. Concentrator

2. Housing

3. Air inlet

4. Foldable handle

5. Hanging loop

6. Speed control switch

Before using the MARTA MT-1436, observe the following safety measures:

Check the appliance specification and power supply in your network before first use.

The appliance is for indoor, domestic use only and is not intended for industrial use.

Do not use the hair dryer with a damaged cord, plug, or if any other injury has occurred.

Keep the power cord away from sharp edges and hot surfaces.

Always take the plug rather than pulling the cord, and do not reel the cord around the appliance housing.

Never attempt to repair the appliance by yourself; contact a customer service center if problems occur.

Always unplug the appliance and let it cool down before cleaning or removing parts. Keep it unplugged when not in use.

To avoid electric shock and fire, do not immerse the appliance in water or other liquids. If immersion occurs, unplug it immediately.

Do not use the appliance in a bathroom or near water sources.

Ensure that hair, dust, and down do not get into the air inlets, as blocked inlets can cause overheating.

Be careful with the concentrator during operation as it can get hot. Do not touch it while in use.

To use the MARTA MT-1436, follow these steps:

Step 1. Completely unwind the power cord.

Step 2. Set the concentrator onto the hair dryer housing.

Step 3. Plug the appliance into the power outlet.

Step 4. Use the speed control switch to adjust the airflow power to your desired setting.

The MARTA MT-1436 is equipped with a speed control switch to adjust the power of the airflow with the following settings:

0: Off

1: Medium airflow power for delicate drying and styling

2: High airflow power for fast drying

Concentrator: This attachment is used for focused airflow, allowing you to dry and style each hair lock individually.

Foldable handle: The MARTA MT-1436 features a foldable handle designed for convenient storage and easy handling.

If the MARTA MT-1436 overheats, it will switch off automatically. If this happens, set the switch to position 0, unplug the appliance, and wait until it is completely cooled down. Before turning it back on, check the air inlets to ensure there is no hair, dust, or other objects blocking them.

Follow these cleaning and maintenance instructions for the MARTA MT-1436:

Always unplug the appliance before cleaning and let it cool down completely.

Clean the appliance housing using a wet cloth.

Remove the concentrator and rinse it in warm soapy water.

Wipe the housing and the concentrator dry with a smooth, dry cloth.

Do not use chemical or abrasive cleaners for cleaning.

To store the MARTA MT-1436 properly:

Ensure the appliance has cooled down completely before putting it away.

Make sure there is no water on the surface of the appliance.

Do not reel the cord around the appliance housing as this may cause cord damage.

Store the hair dryer in a dry, cool place.

The technical specifications for the MARTA MT-1436 are as follows: