LOGITECH G305 SE (01) PDF MANUAL

1. Remove the battery cover by pressing the top of the cover and pulling it downwards.
2. Remove the receiver.
3. Insert the battery.
4. Close the battery cover.
5. Make sure the mouse is turned on via the switch on the bottom of the mouse.
6. Download the G HUB software.

1. Left (Button 1)
2. Right (Button 2)
3. Wheel click (Button 3)
4. Forward (Button 4)
5. Back (Button 5)
6. DPI cycle (Button 6)

The On/Off switch is located on the bottom of the mouse and is not programmable.

Battery life

• Flashing red: battery <15%

DPI

• Yellow: step 1 – 400 DPI
• White: step 2 – 800 DPI (default)
• Orange: step 3 – 1600 DPI
• Magenta: step 4 – 3200 DPI
• Blue: step 5 – 6400 DPI (Step 5 can be activated via software only)

Mode

• Cyan: performance mode (default)
• Green: endurance mode (can be activated via software only).

Tips:

• Activating endurance mode will degrade tracking performance but improve battery life.

You can customize the onboard profile settings using the G HUB. These settings include button programming, report rate, performance/endurance modes and tracking behavior. G304 SE / G305 SE allows up to 5 DPI settings.

By default, G304 SE / G305 SE has the following settings:

• DPI: 400/800/1600/3200
• Report rate: 1ms
• Performance mode