LINEA DOMO DO9253IB (01) PDF Document

When using the LINEA DOMO DO9253IB ice maker, basic safety precautions should always be taken, including the following:

• Read all instructions carefully. Keep the manual for future reference.

• Make sure all packaging materials and promotional stickers have been removed before using the appliance for the first time. Make sure children cannot play with the packaging materials.

• This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments.

• Children should be supervised to ensure that they do not play with the appliance.

• This appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 16 and supervised.

• Keep the appliance and its cord out of reach of children younger than 16 years.

• Attention: This appliance cannot be used with an external timer or a separate remote control.

• Before use, check if the voltage stated on the appliance corresponds with the voltage of the power net at your home.

• Do not let the cord hang on a hot surface or on the edge of a table or counter top.

• Never use the appliance when the cord or plug is damaged, after malfunction or when the appliance itself is damaged. In that case, take the appliance to the nearest qualified service center for check-up and repair.

• Close supervision is necessary when the appliance is used near or by children.

• The use of accessories that are not recommended or sold by the manufacturer can cause fire, electrical shock or injuries.

• Unplug the appliance when it is not in use, before assembling or disassembling any parts and before cleaning the appliance. Put all buttons and knobs into the ‘off’ position and unplug the appliance by grasping the plug. Never unplug by pulling the cord.

• Do not leave a working appliance unattended.

• Never place this appliance near a gas stove or electrical stove or in a place where it may come into contact with a warm appliance.

• Do not use the appliance outdoors.

• Only use the appliance for its intended use.

• Always use the appliance on a steady, dry and level surface.

• Only use the appliance for domestic use. The manufacturer can not be held responsible for accidents that result from improper use of the appliance or not following the instructions described in this manual.

• All repairs should be carried out by the manufacturer or its aftersales service.

• Never immerse the appliance, the cord or the plug in water or any other liquid.

• Make sure that children do not touch the cord or appliance.

• Keep the cord away from sharp edges and hot parts or other heat sources.

• Do not tilt the appliance over 45°.

• Place the appliance at least 15 cm away from other objects to ensure a proper ventilation around the appliance.

• Do not switch the appliance on and off too frequently. Always wait for at least 5 minutes to prevent damage to the compressor.

• Caution: risk of fire / flammable materials. This appliance uses a flammable refrigerant. If the refrigerant is leaked and exposed to an external ignition source, there is a risk of fire.

The LINEA DOMO DO9253IB ice maker consists of the following parts:

1. Water tray

2. Freeze fingers

3. Ice shovel

4. Full basket sensor

5. Ice basket

6. Control panel

7. Ventilation opening

8. Drain hole with plug

9. Scoop

The control panel of the LINEA DOMO DO9253IB has the following indicators:

10. Indicator light ‘water reservoir empty’ (ADD WATER)

11. Indicator light ‘ice basket full’ (ICE FULL)

12. Indicator light ‘in operation’ (ICE)

13. On/off button

Before using the LINEA DOMO DO9253IB ice cube maker for the first time, follow these steps:

1. Make sure all packaging materials and promotional stickers have been removed.

2. Wait 2 hours after putting the appliance in place and leave the lid open for at least 2 hours.

3. Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are not blocked.

4. Clean the device according to the instructions in the ‘Cleaning and maintenance’ section.

1. Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are not blocked.

2. Open the lid and take out the ice basket so you can pour water into the water tank. It is recommended to use spring water or mineral water.

– Caution: Make sure that the water level is lower than the maximum indication. If the water tank is filled above the MAX indication, drain the excess water through the drain hole at the bottom of the ice cube maker. Open the drainage hole on the underside of the appliance above a collecting container or a sink. Always ensure that the opening is closed properly before use.

– Use water at room temperature. The recommended temperature is between 8°C and 25°C.

3. Place the basket back into the appliance and close the lid.

4. Plug the power cord into a socket. The ‘in operation’ indicator light will start flashing. Press the on/off button on the appliance to turn it on. The indicator light comes on and the ice-making cycle starts.

5. When the cycle is over, the ice cubes fall from the cold fingers and are pushed by the ice scoop into the ice basket. The following cycle starts automatically. If you do not remove the ice cubes from the ice basket, they will gradually melt. The meltwater is captured in the water reservoir for reuse.

6. When the desired amount of ice is ready, you can switch off the device by pressing the on/off button. Unplug the power cord after use.

7. Clean the appliance after each use. Empty the water reservoir before storing the appliance. Open the drainage hole on the underside of the appliance above a collecting container or a sink.

Note: During the first 3 cycles, the ice cubes may be smaller and more irregular in size. When the ice basket is full, immediately remove the ice from the ice basket.

Indicator Light Information:

• If the ‘water reservoir empty’ (ADD WATER) indicator lamp lights up, there is not enough water left in the water reservoir. Fill the water reservoir with water and press the on/off button to restart the machine. If you do not press the on/off button after the reservoir is full, the device will automatically restart after 30 minutes.

• If the ‘ice basket full’ (ICE FULL) indicator light flashes, the machine will stop working. Empty the ice basket. If there is no more ice near the sensor, the appliance will restart automatically.

• Never immerse the appliance, the cord or the plug in water or any other liquid.

• Switch off the appliance and unplug before cleaning. Also remove all ice cubes.

• Drain all water from the water tank through the drain hole at the bottom of the ice cube maker. Open the drainage hole on the underside of the appliance above a collecting container or a sink.

• Regularly clean the ice basket, the water tank, the water tray, the freeze fingers and the ice shovel. Use a damp cloth, maybe with a little mild detergent, to clean the inside and the outside of the ice cube maker. Rinse thoroughly before using the appliance again.

• Do not use any chemical products or products containing acids, gasoline or oil.

• Do not use any mechanical appliances or other aids to speed up the freezing process.

• Replace the water in the water tank at least once a day to guarantee clean ice cubes. When not using the appliance, always drain the water from the water tank. Always use clean water when using the ice cube maker.

Descale the appliance regularly to avoid calcification and to maintain a well-operating appliance. Use a descaling product for coffee makers, or use a solution of 1/2 vinegar and 1/2 water.

1. Fill the water tank with the product/solution (do not exceed the maximum level) and switch on the appliance.

2. The appliance will now pump water into the ice tray. Wait until the tray is filled with water (the supply of water to the tray will stop) and immediately press the ON/OFF button.

3. The appliance switches off and will release the product/solution from the ice tray.

4. Repeat this cycle a few times with the descaling product/solution.

5. Afterwards, fill the water tank with clean water and repeat the procedure until the smell of the descaling product/solution has disappeared completely.