LINEA DOMO DO8306TP (01) PDF Document

Read all instructions carefully and keep the manual for future reference.

Make sure all packaging materials and promotional stickers have been removed before using the appliance for the first time. Make sure children cannot play with the packaging materials.

This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments.

Children should be supervised to ensure that they do not play with the appliance.

This appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 16 and supervised.

Keep the appliance and its cord out of reach of children younger than 16 years.

The appliance must be disconnected from its power source when not in use, during service and when replacing parts. Allow to cool before putting on or taking off parts, and before cleaning the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

CAUTION: In order to avoid a hazard this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

The supply cord should be regularly examined for signs of damage, and if the cord is damaged, the appliance must not be used.

The appliance must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.

The appliance is to be connected to a socket-outlet having an earthing contact.

The surfaces of the appliance are likely to get hot during use. It is advised not to touch the surfaces of the appliance other than the handles to avoid burns.

Never leave the appliance unattended while it is functioning.

Do not use or store this appliance outdoors.

Do not move the appliance while in use or when still hot. Allow to cool before moving the appliance.

Do not use this appliance for other than intended use.

Check carefully that the voltage and frequency match the indications on the rating label of the appliance.

The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local standards and requirements.

Only use the utensils delivered with the appliance.

Do not operate this appliance with a damaged cord or plug or in the event the appliance malfunctions or has been damaged in any manner.

To protect against electrical shock or burns, do not immerse unit, cord, or plug in water or other liquid.

A short power supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord. DO NOT USE WITH AN EXTENSION CORD.

Unwrap the cord completely to prevent overheating of the cord.

Do not let the power supply cord hang over the edge of counter, or touch hot surfaces.

Do not allow the power cord supply to run underneath or around the unit.

Do not place on or near a hot gas or electric burner or sink, or in a heated oven.

Do not place near flammable materials, gases or explosives.

Do not place near objects that may catch fire such as curtains, towels.

Make sure the appliance is correctly assembled, then plug the cord in the wall outlet. To disconnect, turn controls to “OFF” or “0” position then remove plug from wall. Never pull the cord or appliance to remove the plug from the socket.

Do not use the appliance if there is any water in it or the parts are still wet after cleaning.

Failure to maintain this appliance in a clean condition could adversely affect the life of the appliance and possibly result in a hazardous situation.

Do not use the product on a surface which could be damaged by heat or steam.

Always place the appliance on a flat and stable surface.

1. Backing surface with non-stick Teflon coating

2. Removable adaptor with thermostat and indicator light

3. ‘Cool touch’ handles

4. Catch basin for fat and moisture

Remove all packaging materials and clean the appliance carefully before using for the first time.

The appliance heats up during use, so place the appliance on a heat-resistant surface and never put it on a plastic table or plastic tablecloth.

Make sure there is adequate ventilation around the appliance. Turn the teppanyaki plate on for 10 minutes without putting any food on it. There will be a small amount of smoke and a slight odour that will disappear quickly. This is normal. Clean the teppanyaki plate with absorbent paper or a clean dry cloth to remove any residue.

It is recommended that you grease the griddle with a small amount of oil when using it for the very first time.

Make sure that sharp objects such as forks do not damage the special coating on the teppanyaki. Small fragments could become loose and your appliance could get irreparably damaged. Always use the wooden spatulas or a heat resistant plastic model.

Set the thermostat to 0 and plug the adaptor into the appliance. Put the plug in the socket.

You can set the temperature of the appliance as desired. The temperature ranges from a minimum of (0) to a maximum of (5). A medium temperature is recommended.

This switch is also the on/off switch, and 0 is the off position.

Turn the temperature regulator to the desired position. The red indicator light will light up to show that the appliance is in use.

Defrost frozen food before laying it on the teppanyaki.

In order to grill meat adjust the thermostat to maximum and make sure that the appliance is thoroughly heated before laying the meat on the griddle.

If you only need to use a part of the teppanyaki, then place the food in the middle to obtain the ideal cooking result.

Set the thermostat to minimum (0), remove the plug from the socket and wait until the teppanyaki has cooled down completely.

It is recommended that all food residues be removed with a wooden spatula or a heat-resistant plastic utensil while the appliance is still hot. If the residues dry up, they will be harder to remove.

Do not immerse any part of the teppanyaki plate in water or any other liquid. Should water get on the electrical contacts, dry them off carefully.

Wipe the baking tray clean with a soft cloth or kitchen roll. For the removal of dried food residues, use a soft sponge with hot water and a small amount of dish-washing detergent.

The catch basin for fat and moisture can be removed for easy cleaning. Clean it in hot water using a mild detergent.

Do not use any corrosive or abrasive products or brushes.