LINEA DOMO DO7344H (01) PDF Document

When using the LINEA DOMO DO7344H, basic safety precautions should always be taken, including the following:

Read all instructions carefully and keep the manual for future reference.

Ensure all packaging materials and promotional stickers are removed before first use.

This appliance is for household and similar applications. Children should be supervised to ensure they do not play with the appliance.

The appliance can be used by children aged 16 and above and persons with reduced capabilities if they have been given supervision or instruction. Cleaning and maintenance should not be done by children unless they are older than 16 and supervised.

Keep the appliance and its cord out of reach of children younger than 16 years.

The appliance can become hot during use. Keep the power cord away from hot parts.

Before use, check that the voltage on the appliance corresponds with your home’s power net voltage.

Do not let the cord hang on a hot surface or on the edge of a table.

Never use the appliance if the cord or plug is damaged, after a malfunction, or if the appliance itself is damaged. Take it to a qualified service center.

Unplug the appliance when not in use, before assembly/disassembly, and before cleaning. Put all buttons to ‘off’ and unplug by grasping the plug, not pulling the cord.

Do not leave a working appliance unattended.

Never place the appliance near a gas or electrical stove or where it may contact a warm appliance.

Do not use the appliance outdoors.

Only use the appliance for its intended domestic use.

Always use the appliance on a steady, dry, and level surface.

This product is only suitable for well-insulated spaces or occasional use.

Never immerse the appliance, cord, or plug in water or any other liquid.

Keep the cord away from sharp edges, hot parts, or other heat sources.

The appliance is not for use in bathrooms, washing areas, or other damp areas. A person in a bathtub or shower should not be able to touch the appliance, power cord, or control knobs.

No, the LINEA DOMO DO7344H cannot be used with an external timer or a separate remote control.

You must not cover the appliance. Covering it can lead to overheating.

The LINEA DOMO DO7344H consists of the following parts:

1. Air outlet

2. Air inlet

3. Dust filter

4. On/off switch

5. Handle

6. Control panel with display

7. On/off switch (on control panel)

8. Timer and temperature setting button

9. Power setting button (2500 W or 1500 W)

10. Eco mode button

11. Remote control

Before the first use of your LINEA DOMO DO7344H, follow these steps:

The heater should be operated at a minimum distance of 50 cm from any wall or other object.

Position the air flow to optimize the heating of the room. Avoid corners, small volumes, floors, and ceilings.

Place the appliance on a smooth, stable surface.

When the appliance is switched on for the first time, a slight smell may be emitted. Please ensure sufficient ventilation. This smell will disappear very quickly.

Before using the appliance with the remote control, a coin cell battery (CR2032) must be placed in the remote control. This is provided. The remote control has a range of 5 metres.

Before you use the appliance, plug it in and turn on the on/off switch at the back of the device. The heater will now be in stand-by mode. You can set the appliance using the control panel or the remote control. The display will show the selected settings.

Push the on/off switch on the control panel or remote to turn the appliance on or off. A signal will indicate that the appliance is operating. After switching off, the appliance will cool itself for a while. The heater remembers the last settings made, which will appear on the display when you switch it on again.

To change the power setting on your LINEA DOMO DO7344H, use the power setting button:

Push the button once for high power: 2500 W.

Push the button twice for low power: 1500 W.

To set the timer on your LINEA DOMO DO7344H, follow these steps:

1. Push the settings button once to set the timer.

2. The timer can be set between 1 and 12 hours. Use the + and – buttons to select the desired time. Pressing the + or – button sets the time with one hour more or less. You can also press and hold the button to reach the desired setting faster.

3. When the selected time has expired, the appliance will enter stand-by mode and will no longer emit heat.

To set the temperature on your LINEA DOMO DO7344H, follow these steps:

1. Press the settings button twice to set the temperature.

2. The temperature can be set between 5°C and 35°C. Use the + and – buttons to select the desired temperature. Pressing the + or – button sets the temperature one degree higher or lower. You can also press and hold the button until you reach the desired setting.

If you have set the timer and temperature, press the settings button a third time. The display will show the ambient temperature. The settings are now fixed and cannot be adjusted unless you push the settings button again.

Note: If both the timer and temperature are set, both settings will appear alternately on the display.

Push the ECO button to enter eco mode. This function ensures that the set temperature will be maintained in an energy-efficient way.

If the ambient temperature is a maximum of 2°C lower than the set temperature, the appliance will reach the set temperature at the lower power of 1500 W.

If the ambient temperature is more than 2°C lower than the set temperature, the appliance will reach the set temperature at the higher power of 2500 W.

If the temperature is reached, the appliance will enter stand-by mode. If the temperature decreases again, the appliance will re-enter eco-mode.

The LINEA DOMO DO7344H is equipped with two key safety features:

Overheat Protection: This feature switches off the heater automatically in case of overheat, for example, due to total or partial obstruction of the grids. If this happens, unplug the appliance, wait about 10 minutes for it to cool, and remove the object that is obstructing the grids. Then switch it back on. The appliance should operate normally. If the problem persists, contact customer service.

Tip-Over Safety: This safety feature is integrated into the appliance. The appliance will turn off automatically if it tips over.

Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.

To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the housing with a damp cloth.

If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum cleaner. This maintenance should be done regularly to ensure the good operation of the appliance. Dust particles in the appliance may cause over-heating.

Store the appliance in a clean and dry place.

The symbol on the product or its packaging indicates that this product may not be treated as household waste. Instead, it must be brought to the applicable collection point for recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The packaging is recyclable; please treat the packaging ecologically.