LELO SMART WAND 2 LARGE (01) PDF Document

The LELO SMART WAND 2 LARGE is locked for transportation. To unlock it, you can simply connect it to the charger. Alternatively, you can press and hold the + and – buttons simultaneously for 3 seconds until the light turns on.

Once the device is unlocked, follow these steps to operate the LELO SMART WAND 2 LARGE:

Press the + button to turn the device on; press it again to increase the vibration strength.

Press the center ( ) button to switch between the 10 different vibration patterns.

Press the – button to reduce the vibration strength.

Press and hold the center ( ) button to turn the device off.

Before first use, you should charge the LELO SMART WAND 2 LARGE for 2 hours. To charge the device, insert the DC plug into the DC port located at the base of the wand and insert the mains plug into a wall socket. Only use original chargers provided by LELO. The LED on the interface will pulse to indicate that it is charging. It typically takes about 1.5 hours to reach a full charge, at which point the LED will emit a steady glow.

When the battery is running low, the LED on the LELO SMART WAND 2 LARGE will emit a blinking white light.

The LELO SMART WAND 2 LARGE is fully waterproof, making cleaning simple. You should clean the device thoroughly before and after each use using the following steps:

Wash the silicone with warm water and antibacterial soap, or spray with LELO Toy Cleaner.

Rinse with clean hot water and pat dry with a lint-free cloth or towel.

Never use cleansers containing alcohol, petrol, or acetone.

Store the device in a dust-free place, away from products made of other materials. Avoid leaving it in direct sunlight and never expose it to extreme heat.

You should avoid using the LELO SMART WAND 2 LARGE with hand creams or silicone-based lubricants, as these may make the silicone surface permanently tacky. It is recommended to use only water-based lubricants.

If the LED does not pulse when connected, it may be due to one of the following reasons:

The battery is completely drained and will require several minutes to acknowledge that it is being charged.

The charger is not properly connected. Please check both the wall socket and the DC socket at the base of the device.

If the device does not turn on, try the following troubleshooting steps:

The battery may be empty. Recharge the device.

The interface may be locked. Hold down the + and – buttons for 5 seconds to unlock the device.