KUSSMAUL 091-239 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Click here to download KUSSMAUL 091-239 (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** INs-rnucT10N MANUAL DASH MOUNT ACCESSORY ENCLOSURE PROVIDES STYLISH EASY MOUNTING ACCEPTS A1-L. KUSSMAUL. DASH MOUNTED ACCESSORIES SIZE 1.4″ X 0.8″ BATTERY BLUETOOTH pnig ggsspaAUL File: 1M 091 -eas revA.indd Revised ay: SO Date: oe-ao-201 5 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com OFF M0DEl- # : 091-239 a YEAR WARRANTY eKiJSSiVlAlJL ELECTRONICS ENERGIZED AND READY) WHEN SECONDS COUNT LJ$PORT ussMAUL scan using your mobile device for more information Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com

****** Page 2 ****** INTRODUCTION The Kussmaul Dash Mount is a product made for our new dash-mountable switch accessories. Normally, a dashboard switch must be placed into a slot in the dashboard by making a cut-out for singular switches or using a gang mount which requires modifying the dashboard. This box will hold up to 5 Kussmaul Switch Accessories and can be mounted easily above the dashboard, underneath the dashboard, or from the vehicle roof making the Kussmaul Dash Mount an easy choice to add space for retrofittable vehicle accessories in your emergency or utility vehicle. FEATURES Mounts to any dashboard in minutes • Accepts five (5) Kussmaul Dash Mounted Accessories 1.4″ x 0.8″ • Heyco PG9 Strain Relief on rear panel for wires 3 Year Warranty INSTALLATION l. Switch Installation 1. Remove top four (4) screws from Cover and lift Cover. 2. Install accessories into Openings and dress wires through the feedthrough in rear panel. 3. Replace Cover and four (4) screws. II. Mounting The Kussmaul Dash Mount is designed to mount from the vehicle roof (bracket above), above the dashboard (bracket below) or below the dashboard (bracket above). • Allow 9″ x 5″ of area for the Dash Mount Accessory. Locate the area for mounting the Dash Mount Accessory. • Drill two (2) 0.201″ holes 5″ apart. • Remove the 7 % ” Bracket from the housing by removing the two (2) thumb screws. • Attached the bracket with 10-32 hardware (not included). • Replace the housing onto the Bracket using the two (2) thumb screws. Adjust the viewing angle and tighten the Thumb Screws. 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com eKiJSSiVlAlJL ELECTRONICS ENERGIZED AND READY) WHEN SECONDS COUNT Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com

****** Page 3 ****** INSTALLATION WIRING DIAGRAM Cover Openings OUTLINE DRAWING 3.10″ View With Cover Removed 0 Remove top screws to gain access (4 places) Screw 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com 7.50″ eKiJSSiVlAlJL ELECTRONICS ENERGIZED AND READY) WHEN SECONDS COUNT Bracket Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com 3

****** Page 4 ****** AVAILABLE SWITCH ACCESSORIES ON OFF USSMAUL Auto Touch #091-222 BATTERY FULL Low RussMAtJL Mini Single Bar Graph Display #091-234 Works with all Kussmaul Electronics switches that TEMPERATURE 82 KUSSMAUL Temperature Monitor #091-224 use PORT KussMAUL USB Dual Port #091-219 fit into cut-out size 1.45″ x 0.83″ 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com eKiJSSMAlJL ELECTRONICS ENERGIZED AND READY, WHEN SECONDS COUNT Data Port #091-227 BLUETOOTH READY RussbåAUL Bluetooth Module #091-226 Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com

****** Page 5 ****** INSTALLATION RECORD DATE INSTALLED INSTALLED BY VEHICLE IDENTIFICATION VEHICLE OWNER WARRANTY POI-ICY All products of Kussmaul Electronics are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Defective products should be returned to Kussmaul Electronics with shipping charges prepaid. Upon repair, products will be returned to customer with shipping charges paid. Kussmaul Electronics shall have no liability for damages of any kind to associated equipment arising from the installation and/or use of the Kussmaul Electronics products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. Members of Fire and Emergency Manufacturers and Service Association EMS Members of National Fire Protection Association Members of Fire Apparatus Manufacturers Association NFPA Made in USA 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com eKiJSSMAlJL ELECTRONICS ENERGIZED AND READY, WHEN SECONDS COUNT AMA Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.