Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** INSTRUCTION MANUAL- AUTO TOUCH LOW-SIDE TOUCH SENSITIVE SWITCH The 091-222 Auto Touch is designed to fit into a standard 1.45″ x 0.83′ panel cut-out. Connect the red wire to either +12 Volts continuous (battery positive) or switched 12 Volt power (igni- tion) using an 8 amp fuse. Connect the black wire directly to chassis ground (battery nega- tive). The green wire is a switched ground. The low-side of the load should be connected to the green wire. O OFF KussnnAlJL DESCRIPTION RED BLACK 8 amp fuse 12 Volt Battery LOAD GRN Wiring Diagram: 5 AMPS OR LESS The Auto Touch is a low-side touch sensitive switch that is used as an on/off switch. Capacitive sense technology is used to sense the touch of a finger. To turn on the load, touch the on/off area of the front panel and a LED will illuminate. To turn off, just touch the on/off area again the load and LED will turn off. SPECIFICATIONS Input Voltage: 8 to 20 VDC Nominal (6 to 23 VDC absolute min./max.) Quiescent Current: 0.020 Amps Max Switch Rating: 5 Amps Max PPLICATION NOTE BLK RED Warranty: 3 years 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com File: IM_091 -222_revA.indd Revised By: PSS Date: 9-03-2014 12 BATTERY RELAY GRN Wiring Diagram: > 5 AMPS KUSSMAUL ELECTRONICS ENERGIZED AND READY WHEN SECONDS COUNT Ph: 800-346-0857 Fax: 631-567-5826 firstname.lastname@example.org
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL