KONIG ELECTRONIC HC-MG300 (01) PDF Document

You should not use the KONIG ELECTRONIC HC-MG300 while walking, driving, or bathing.

Please take off your contact lenses before using the KONIG ELECTRONIC HC-MG300.

Do not use the KONIG ELECTRONIC HC-MG300 if you are suffering from glaucoma, retinoschisis, or other serious eye diseases.

Please follow your doctor’s advice if you are shortsighted by 800 degrees or above when using the KONIG ELECTRONIC HC-MG300.

You can use alkaline batteries or the DC adapter with the KONIG ELECTRONIC HC-MG300.

Remove the batteries from the KONIG ELECTRONIC HC-MG300 when you are using the DC adapter.

Do not drop the main unit of the KONIG ELECTRONIC HC-MG300 on the ground or immerse it in water. Also, avoid exposing the unit to humidity, strong sunlight, or corrosive gas.

Please do not wash the eye mask of the KONIG ELECTRONIC HC-MG300 in water. Clean it lightly by using alcohol if necessary.

Please keep your eyes closed for 1 to 3 minutes and then open them slowly after using the KONIG ELECTRONIC HC-MG300.

To install batteries in the KONIG ELECTRONIC HC-MG300, open the battery cover of the controller and insert 4 AA batteries according to the indicated polarity, then close the battery cover.

To use the adapter with the KONIG ELECTRONIC HC-MG300, connect the adapter to an AC power socket properly and plug the DC pin into the DC socket of the controller.

First, level the eye mask of the KONIG ELECTRONIC HC-MG300 with your eyes. Then, adjust the elastic to a proper length and fix it around your head. Connect the earphone to the socket if desired, then press the On/Off button to activate the device.

When the KONIG ELECTRONIC HC-MG300 is activated, the working indicator light flashes. When the device is stopped, no lights are illuminated.

The KONIG ELECTRONIC HC-MG300 works automatically in the following order: Air pressure + Heating, then Vibrating + Heating, and finally Air pressure + Vibrating.

Press the Air pressure button on the KONIG ELECTRONIC HC-MG300 to cycle through modes: Massage Temple and Eyes, Massage Eyes, or Massage Temple.

Press the Heating button on the KONIG ELECTRONIC HC-MG300 to switch between Higher Temperature, Lower Temperature, and No heating.

Press the Time button on the KONIG ELECTRONIC HC-MG300 to choose between 5 minutes, 10 minutes, or 15 minutes.

Press the Vibrating button on the KONIG ELECTRONIC HC-MG300 to cycle through different vibration types, including various kneading, beating, and swinging modes.

Press the Music button briskly on the KONIG ELECTRONIC HC-MG300 to choose any music mode (Piano Music I, or Natural Music I-V). Press and hold the Music button to switch off the music function.

To reduce the risk of electric shock, the KONIG ELECTRONIC HC-MG300 should ONLY be opened by an authorized technician. Disconnect the product from the mains and other equipment if a problem should occur.

Clean the KONIG ELECTRONIC HC-MG300 only with a dry cloth. Do not use cleaning solvents or abrasives.

The operating temperature for the KONIG ELECTRONIC HC-MG300 is 5C to 40C, with a relative humidity of less than 80% and air pressure between 860 hPa and 1060 hPa.

The KONIG ELECTRONIC HC-MG300 requires a 220V AC power supply or a 6V DC power source with a power consumption of less than 4W.

No guarantee or liability can be accepted by the manufacturer for any changes or modifications made to the KONIG ELECTRONIC HC-MG300.

The KONIG ELECTRONIC HC-MG300 is marked with a symbol indicating that used electrical and electronic products should not be mixed with general household waste and must be taken to a separate collection system.

The vibration frequency of the KONIG ELECTRONIC HC-MG300 is between 40 Hz and 100 Hz.

The heating temperature for the KONIG ELECTRONIC HC-MG300 is between 30C and 45C.

Always check the anode and cathode of the batteries for the KONIG ELECTRONIC HC-MG300 to ensure they are correctly installed and that the battery cover is kept tightly closed.

The controller dimensions for the KONIG ELECTRONIC HC-MG300 are 14.1 cm x 6.85 cm x 4.40 cm.

The main mask dimensions for the KONIG ELECTRONIC HC-MG300 are 29.50 cm x 10.50 cm x 10.00 cm.

Check the battery holder inside the KONIG ELECTRONIC HC-MG300 controller; the polarity is indicated inside the battery compartment.

The KONIG ELECTRONIC HC-MG300 operates within an environment with a magnetic field intensity greater than 200 Mt.

Yes, the KONIG ELECTRONIC HC-MG300 carries a warning regarding the risk of electric shock and explicitly states “DO NOT OPEN”.

You should keep this manual for the KONIG ELECTRONIC HC-MG300 for future reference.

If the KONIG ELECTRONIC HC-MG300 encounters problems during operation, you should disconnect the product from the power source and all other equipment.

The total weight of the KONIG ELECTRONIC HC-MG300 is less than 0.5 kg.

Slide the buckle on the elastic strap of the KONIG ELECTRONIC HC-MG300 to adjust it to the correct length that fits comfortably around your head.

Yes, the KONIG ELECTRONIC HC-MG300 features an earphone jack to listen to the built-in music.

The KONIG ELECTRONIC HC-MG300 includes Piano Music I, and Natural Music modes: Babbling brook, Bird call, Ocean Wave, Cricket Call, and Dripping Water.

When the KONIG ELECTRONIC HC-MG300 is set to a 5-minute timer, the indicators for air pressure, heating, and music will blink during the session.

The vibrating mode of the KONIG ELECTRONIC HC-MG300 can be set to 11 different types of vibration.

The designs and specifications of the KONIG ELECTRONIC HC-MG300 are subject to change without notice.

The DC jack on the KONIG ELECTRONIC HC-MG300 supports a 6V DC, 1000mA power input.

No guarantee can be accepted by the manufacturer for damage caused due to incorrect use or unauthorized modifications to the KONIG ELECTRONIC HC-MG300.

Ensure that the DC pin of the power adapter is firmly inserted into the corresponding DC socket located on the KONIG ELECTRONIC HC-MG300 controller.

The KONIG ELECTRONIC HC-MG300 has a power consumption of less than 4 W.

You should place the KONIG ELECTRONIC HC-MG300 mask so that it is level with your eyes to ensure effective massage coverage.

Blinking indicators on the KONIG ELECTRONIC HC-MG300 are a normal sign of operation, showing active settings like air pressure, heating, and time.

The operating temperature for the KONIG ELECTRONIC HC-MG300 is 5C to 40C, so use it within this range.

No, the KONIG ELECTRONIC HC-MG300 is not waterproof and should not be submerged in water or washed under a tap.

Press the On/Off button to deactivate the KONIG ELECTRONIC HC-MG300; the indicator light will turn off.

All logos and product names associated with the KONIG ELECTRONIC HC-MG300 are trademarks or registered trademarks of their respective holders and are recognized as such.