KOBE CH3836SQB-1 (01) PDF Document

To operate the fan function on the KOBE CH3836SQB-1, press the buttons to choose your desired speed setting: Q for QuietMode speed, L for Low speed, or H for High speed. To turn the fan off, press the OFF button.

To operate the light on the KOBE CH3836SQB-1, simply press the Light Control button to turn the lights on and off.

To clean the surface of the KOBE CH3836SQB-1, use only mild soap or detergent solutions and dry the surfaces using a soft cloth. If the hood looks splotchy, use a stainless steel cleaner. Follow the directions of the stainless steel cleaner, but do not leave it on for too long as it may damage the finish. Wipe off the cleaning solution with a soft towel and gently rub off any stubborn spots, then use a dry soft towel to dry the hood. Do not use abrasive cleaners, pads, or cloths, and do not use ordinary steel wool or steel brushes.

To clean the baffle filters and spacers of the KOBE CH3836SQB-1, first remove all baffle filters, spacers, and the oil tunnel if present. Wash them with a sponge using warm soapy water and dry them completely before returning them into place. Note that the baffle filters are top rack dishwasher safe.

If the lights on your KOBE CH3836SQB-1 are working but the motor is not, check the following potential causes and solutions:

1. The motor may be defective: Replace the motor.

2. The capacitor(s) may be defective: Replace the capacitor(s).

3. The control panel may be defective: Replace the control panel.

If your KOBE CH3836SQB-1 is vibrating, consider the following troubleshooting steps:

1. The blower system is not secure: Tighten the turbine impeller, squirrel cage, and air chamber.

2. The turbine impeller or squirrel cage is not balanced: Replace the turbine impeller or squirrel cage.

3. The hood is not secured in place: Check the installation of the hood and tighten the mounting bracket.

If your KOBE CH3836SQB-1 is not venting correctly, check the following solutions:

1. Ensure the range hood is installed at the manufacturer recommended clearance of 26 inches to 30 inches between the hood and the cooktop.

2. Ensure there is make-up air inside the house by opening a window to enhance the performance of the hood.

3. Remove any obstacles blocking the duct work.

4. If the pipe size is smaller than the suggested size, change the ducting according to the manufacturer’s suggestion.

If cold air is coming into the home through the KOBE CH3836SQB-1, check the following:

1. Ensure the pipe connection is properly sealed.

2. Check if the damper is properly installed or missing.

3. If the damper is not installed, install it to help eliminate air backflow.

The performance specifications for the KOBE CH3836SQB-1 are as follows: