KENMORE 796.9128 (01) PDF Document

To operate the KENMORE 796.9128, follow these steps:

Step 1. Clean the lint filter. Lift out the filter and remove lint from the last load to ensure efficient performance.

Step 2. Load the dryer with wet laundry from the washer. If the load is extra large, divide it into smaller loads.

Step 3. Press the POWER button to turn the unit on.

Step 4. Select a cycle by rotating the cycle selector knob until the desired cycle LED is illuminated.

Step 5. Select cycle modifiers by changing the default settings if desired. Note that not all modifiers are available for every cycle.

Step 6. Select cycle options using the option buttons.

Step 7. Press the START/PAUSE button to begin the cycle.

Step 8. When the cycle is finished, remove the clothing immediately to reduce wrinkling. If WRINKLE GUARD is selected, the dryer will tumble briefly every few minutes.

If the KENMORE 796.9128 does not turn on, perform the following checks:

Check 1. Ensure the power cord is properly plugged into a grounded outlet matching the rating plate of the unit.

Check 2. Check if a house fuse is blown or a circuit breaker has tripped. If the circuit is overloaded, have it corrected by a qualified electrician. Do not increase the fuse capacity.

The CHECK VENT indicator on the KENMORE 796.9128 alerts you to exhaust blockages. To clear it:

Step 1. Inspect the exhaust system for blockages, lint buildup, or restricted airflow.

Step 2. Install a shorter or straighter duct run if the system is too long or has too many turns.

Step 3. After the exhaust system is cleaned or repaired, it will take several cycles for the control to verify improved airflow and turn off the indicator light.

The following table outlines the auto dry cycle options for the KENMORE 796.9128:

To save a customized cycle as My Cycle on the KENMORE 796.9128, follow these steps:

Step 1. Press the POWER button to turn on the dryer.

Step 2. Rotate the cycle selector knob to select the desired cycle.

Step 3. Press the cycle modifier button to change settings.

Step 4. Press the cycle option button to add options.

Step 5. Press and hold the MY CYCLE button.

If instructed by a technician, follow these steps to use the Kenmore Connect feature on your KENMORE 796.9128:

Step 1. Turn on the dryer by pressing the POWER button.

Step 2. Hold the mouthpiece of your phone over the POWER button, no more than one inch away, but not touching the unit.

Step 3. Push and hold the TEMP button while continuing to hold the phone to the POWER button.

Step 4. Listen for three beeps. Once heard, release the TEMP button and keep the phone in place for about 6 seconds while the display counts down and the data transmits.

The error codes tE1 or tE2 indicate a temperature sensor failure on the KENMORE 796.9128. You should turn off the dryer and call for service.