ICLEVER IC-GK03 (01) PDF Document

The specifications for the ICLEVER IC-GK03 keyboard are as follows:

Dimensions: 366 x 125 x 16.2 mm / 14.4 x 4.9 x 0.64 in

Operating Range: < 10 m / 32.8 ft

Charge Time: < 2 hours

Uninterrupted Work Time: 90 hours

Lithium Battery Capacity: 280 mAh

Key Life: 3 million clicks

Standby Time: 90 days

The specifications for the ICLEVER IC-GK03 mouse are as follows:

Dimensions: 107.5 x 60 x 27.5 mm / 4.23 x 2.36 x 1.08 in

Operating Range: < 10 m / 32.8 ft

Power Source: 2 x AAA Batteries (not included)

Uninterrupted Work Time: 160 days

Button Life: 3 million clicks

DPI: 1000-1200-1600

The ICLEVER IC-GK03 keyboard features a power switch. Push the switch to the right to turn the keyboard on and to the left to turn it off. When turned on successfully, the power indicator will glow green for 3 seconds.

Step 1. Connect one end of the included USB cable to a USB charger (Output: DC 5.0 V / 500mA), and connect the opposite end to the micro charging port on the ICLEVER IC-GK03 keyboard.

Step 2. The charging indicator will glow red while the keyboard is charging. A full charge takes approximately 2 hours. The indicator will turn off once fully charged.

Step 1. Plug the 2.4G USB receiver into the computer.

Step 2. Turn on the keyboard.

Step 3. Insert 2 x AAA batteries (not included) into the mouse; turn on the mouse.

Step 4. The devices are ready to use.

Step 1. Turn on the keyboard.

Step 2. Press the “Esc+Q” keys at the same time; the indicator will flash green quickly.

Step 3. Immediately plug the 2.4G USB receiver into the computer within 10 seconds and keep the keyboard close to the receiver within 30cm (0.98 ft). Keep the keyboard off the ground during this process.

Step 1. Turn off the mouse and unplug the 2.4G USB receiver.

Step 2. Hold the “mouse right key” and “wheel button” for 3 seconds, then turn on the mouse.

Step 3. Immediately insert the receiver into the computer within 10 seconds and keep the mouse close to the receiver within 30cm (0.98 ft).

Press “Fn + Esc” simultaneously to activate Fn lock; the Fn Lock indicator will turn blue. When activated, you can use the function keys (F1-F12) without needing to press the “Fn” key simultaneously. For Windows tablets, press and hold the “Fn” keys while pressing the F1-F12 keys.

You can adjust the mouse sensitivity between 1000, 1200, and 1600 DPI by pressing the DPI switch button located on the mouse.

If you cannot connect the keyboard and mouse to your device, ensure your device is on, the 2.4G USB receiver is properly inserted into a USB port, the keyboard and mouse are powered, and the devices are within 10m (32.8ft) of your computer.

The ICLEVER IC-GK03 features a Caps Lock indicator that glows green when activated, a Numeric indicator that glows green when NumLock is activated, an Fn Lock indicator that turns blue when activated, and a charging indicator that glows red when the keyboard is charging.