ICLEVER BTH22 (01) PDF Document

In the power off state, press and hold the MFB button for 2 seconds to power on the ICLEVER BTH22. The headphones will play the voice prompt “Power On,” and the indicator light will flash red and blue alternatively, indicating that the headphones have entered pairing mode.

In the power on state, press and hold the MFB button for 4 seconds to power off the ICLEVER BTH22. The headphones will play the voice prompt “Power Off,” and all lights will turn off, indicating that the headphones are powered off.

When first turning on the device, its indicator light flashes slowly in blue, indicating that Bluetooth is in pairing mode with the red and blue lights flashing alternatively. Activate the Bluetooth function on your Bluetooth enabled device. Select the “ICLEVER BTH22” from the list of Bluetooth devices found by your device and connect and you will hear the voice prompt “Connected”.

The ICLEVER BTH22 has two safe volume levels, 85 dB and 74 dB. The default and factory reset positions are both at 85 dB. Short press the “+” and “-” keys at the same time, the volume limit gear will be switched, and the voice broadcast will be performed at the same time.

Use the following controls for the ICLEVER BTH22:

Next Track: Press and hold the volume + button for 1s.

Previous Track: Press and hold the volume – button for 1s.

Play/Pause: Press the MFB button.

Use the following controls for the ICLEVER BTH22 during calls:

Answer/End Call: Press the MFB button.

Reject Call: Press and hold the MFB button for 2s.

Activate/Deactivate Siri: Double the press MFB button.

Switch Between Phone and headphones during a Call: During a call, press and hold the MFB button for 2 seconds.

Answer Third Party Call and Keep Previous Call on Hold: During a call, double press the MFB button.

Call Switching: During a three party call, double press the MFB button.

In the power on state (connected) or pairing mode, simultaneously press and hold the MFB button and Volume – button for 5 seconds and the ICLEVER BTH22 will automatically clear the pairing list and enter pairing mode with the indicator light flashing red and blue alternatively.

Connect the Type C cable to the Type C port on the ICLEVER BTH22, and a 5V power outlet (power adapter is not included). The indicator light will glow red to indicate charging. When the ICLEVER BTH22 is fully charged, the indicator light will change from red to blue.

1. Stop using the ICLEVER BTH22 if it is damaged.

2. Replace the USB interface of the charging cable, if it becomes hot.

3. Keep away the ICLEVER BTH22 from high temperatures and open flames.