HONOR RMO-NX3 (01) PDF Document

To power on your HONOR RMO-NX3, press and hold the power button until the screen turns on.

To power off your device, press and hold the power button, and then touch the power icon.

To restart your device, press and hold the power button, and then touch the restart icon.

Press and hold the Power and Volume down buttons simultaneously for more than 10 seconds to force restart your device.

Be careful not to scratch your device or hurt yourself when using the eject pin.

Store the eject pin out of the reach of children to prevent accidental swallowing or injury.

Do not use cut or modified SIM cards with your device as these may not be recognized and could damage the card tray (slot).

If your SIM card does not match your device, please contact your carrier.

Follow the instructions provided in the guide illustrations to set up your device using the included eject pin.

Ensure that the card is correctly aligned and its notch is first inserted into the card tray.

For a Single-SIM setup, place the card in the slot labeled nano-SIM 1.

For a Dual-SIM setup, place one card in nano-SIM 1 and the second card in nano-SIM 2.

Select the default mobile data card and calling card as needed in the device settings.

Ideal operating temperatures for the device are 0 degrees Celsius to 35 degrees Celsius.

Ideal storage temperatures are -20 degrees Celsius to +45 degrees Celsius.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

Using an unapproved or incompatible power adapter, charger, or battery may damage your device, shorten its lifespan, or cause a fire, explosion, or other hazards.

Keep the device and the battery away from excessive heat and direct sunlight. Do not place them on or in heating devices, such as microwave ovens, stoves, or radiators.

Do not attempt to replace the battery by yourself. This device contains a built-in battery that should only be replaced by an authorized service center.

Dispose of this device, the battery, and accessories according to local regulations. They should not be disposed of in normal household waste.

Pacemaker manufacturers recommend that a minimum distance of 15 cm be maintained between a device and a pacemaker to prevent potential interference. If using a pacemaker, hold the device on the side opposite the pacemaker and do not carry the device in your front pocket.

Observe local laws and regulations while using the device. To reduce the risk of accidents, do not use your wireless device while driving.

While flying in an aircraft or immediately before boarding, only use your device according to instructions provided. Use of a wireless device in an aircraft may disrupt wireless networks, present a hazard to aircraft operation, or be illegal.

If the equipment causes harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

The device IMEI can be obtained by dialing *#06# on the dialer.

To view the FCC ID and regulatory information, go to Settings and touch System and updates followed by Regulatory information.

To use the FM radio function, please connect wired earphones to the device first.