HARMAN-KARDON ONYX STUDIO 2 (01) PDF Document

The buttons on your HARMAN-KARDON ONYX STUDIO 2 perform the following functions:

Power Button: Press to turn the speaker on. Press and hold for more than 3 seconds to turn the speaker off.

Volume Down (-): Press to decrease the volume.

Volume Up (+): Press to increase the volume.

Bluetooth Button: Press to initiate Bluetooth pairing.

Hands-free Button (Phone icon): Press to answer an incoming call.

To pair your HARMAN-KARDON ONYX STUDIO 2 with a Bluetooth device:

1. Press the Bluetooth button on the speaker. The speaker will enter pairing mode.

2. On your Bluetooth-enabled device (e.g., smartphone, tablet), go to the Bluetooth settings.

3. Select “HK ONYX STUDIO 2” from the list of available devices to connect.

To force the HARMAN-KARDON ONYX STUDIO 2 into pairing mode, press and hold the Bluetooth button for more than 2.5 seconds.

When your HARMAN-KARDON ONYX STUDIO 2 is connected to your smartphone via Bluetooth and you receive a call, you can press the hands-free button (phone icon) on the speaker to answer the call. The speaker will then function as a speakerphone.

No. of channels: 4

Transducers: 2 x 3″ woofers, 2 x 3/4″ tweeters, 2 x passive radiators

Bi-amplification: 4 x 15W

Maximum SPL: 95dB @ 1m

Power requirement: 100-240V AC, 50/60Hz

Power adaptor: 19V, 2.0A

Built in battery: 3.7V, 2600mAh, Cylindrical Lithium Ion Rechargeable Battery

Battery charge time: 5 hours

Music playing time: up to 5 hours (varies by volume level and audio content)

Power consumption: 38W maximum <1W standby

Speaker Impedance: 4 ohm per speaker

Frequency response: 60Hz – 20kHz

Frequency range: 2402MHz~2480MHz

Transmitter power: <4dBm

Modulation: GFSK/ π/4-DQPSK/8-DPSK

Wireless: Bluetooth 3.0 A2DP v1.3 AVRCP v1.5

Dimensions (Dia x W x H): 280mm x 161mm x 260mm