HAIER HUF138PA (01) PDF MANUAL

Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following:

1. Use this appliance only for its intended purpose as described in this use and care guide.

2. This appliance must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installation section.

3. This appliance should not be recessed or built into an enclosed cabinet. It is designed for freestanding installation only.

4. Never unplug your appliance by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet.

5. Repair or replace immediately, all electrical service cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length, the plug or the connector end.

6. If your old appliance is not being used, we recommend that you remove the doors and leave the shelves in place. This will reduce the possibility of danger to children.

7. When your freezer is in operation, do not touch the cold surfaces in the freezer compartment, particularly when hands are damp or wet. Skin may adhere to these extremely cold surfaces.

8. Do not use any electrical device or any sharp instrument to defrost your freezer.

9. Unplug your freezer before cleaning or before making any repairs. Note: If for any reason this product requires service, we strongly recommend that a certified technician perform the service.

10. Do not operate your freezer in the presence of explosive fumes.

Do not refreeze foods that have been thawed completely. The United States Department of Agriculture in Home and Garden Bulletin No. 69 reads:

“…You may safely refreeze frozen foods that have thawed if they still contain ice crystals or if they are still cold – below 40°F.”

“…Thawed ground meats, poultry, or fish that have any off-odor or off-color should not be refrozen and should not be eaten. Thawed ice cream should be discarded. If the odor or color of any food is poor or questionable, discard it. The food may be dangerous to eat.”

“…Even partial thawing and re-freezing may reduce the eating quality of foods, particularly fruits, vegetables, and prepared foods. The eating quality of red meats is affected less than that of many other foods. Use refrozen foods as soon as possible, to save as much of their eating quality as you can.”

Risk of child entrapment. Before you throw away your old refrigerator or freezer, take off the doors. Leave the shelves in place so that children may not easily climb inside.

1. Remove all packing materials. This includes the foam base and all adhesive tape holding the accessories inside and outside.

2. Inspect and remove any remaining packaging, tape and printed materials before turning ON the freezer.

Note: Allow the freezer to stand in an upright position for at least 24 hours before turning on the power, if the freezer has been tilted for any reason.

To ensure that your upright freezer works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections.

• The freezer is designed for freestanding installation only. It should not be built-in.

• Allow a minimum of 2 inches on each side and above the top of the freezer to ease installation and allow proper air circulation.

• Be sure to install your freezer on a floor that is strong enough to support the unit when fully loaded.

For personal safety, this appliance must be properly grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electrical current. This appliance is equipped with a cord containing a grounding wire with a grounding plug. The plug must be inserted into an outlet that is properly installed and grounded.

• Improper use of the plug may result in the risk of electric shock.

• Do not, under any circumstances, cut or remove the third (grounding) prong from the power cord.

• Consult a qualified electrician or service center if the grounding instructions are not completely understood or if in doubt as to whether the appliance has been properly grounded.

Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance.

Occasionally, there may be power interruptions due to thunderstorms or other causes. Remove the power cord from the AC outlet when a power outage occurs. When power has been restored, re-plug the power cord into the AC outlet.

• The temperature control dial has settings from “0” to “7” with “1” being the warmest and “7” being the coldest.

• Initially, set the temperature control dial at “4”.

• After the freezer has been turned ON for 24 hours, adjust the temperature control dial to the setting that best suits your needs.

• Turning the temperature control dial to “0” will stop the cooling cycle but will not shut OFF the power.

Note: If you unplug or turn OFF the freezer, wait at least 4 minutes before restarting or plugging it in again.

When turning ON your freezer, the temperature alarm system switch should be at the “O” position. Put it in the “-” position once the freezer has been ON for a period of 24 hours. The temperature alarm is activated at 15.8°F. Once activated, the built-in audible alarm system will signal a warning to you. The alarm will continue to sound until you turn OFF the temperature alarm switch. A red light will also warn you that the temperature alarm system has been activated.

Your freezer has a lock and key feature to secure the contents of the freezer. Close the door, push and turn the key to lock. Push and turn the key in the opposite direction to unlock.

When replacing the light bulb, follow the steps below:

1. Unplug the freezer.

2. Remove the plastic light shade located inside the freezer by lightly pressing to the left side.

3. Remove the light bulb by turning it counter-clockwise.

4. Use ONLY appliance light bulb with 25-watts of power.

5. Install a new replacement light bulb by turning it clockwise.

6. Replace the light shade to its original position.

7. Turn the freezer power ON to see if you have installed the light bulb correctly.

8. If the light bulb does not turn ON, repeat the steps above.

The shelves of the freezer were designed with you in mind. Their adjustability in position allows you to personalize the storage space to your specific needs.

To remove or adjust a full-width, slide-out shelf:

1. Gently tilt the shelf up and slide it towards you until the shelf has been completely removed.

2. To replace the shelf, select the desired setting and gently slide the shelf back until it rests in the locking position.

Note: All shelves are not adjustable.

This freezer is equipped with a reversible door for left/right opening. If you prefer to change the direction of door opening, follow the steps below:

Note: The freezer comes with the door hinged to the right.

1. Fix the freezer door in place with strong adhesive tape.

2. Dismantle the hinge box cover on the top of the freezer door with a Phillips screwdriver and remove the 2 screws from the hinge. Take out the hinge by pulling up vertically. Put these aside.

3. Remove the adhesive tape on the freezer door, lift and take the door down. Carefully put it aside.

4. Remove the door pin from the bracket of the lower hinge by turning it counter clockwise. Move the pin to the opposite hole and tighten.

5. Remove the 4 screws from the lower hinge with a Phillips screwdriver. Remove the washer and shim from the right side and install them to the left side.

6. Align the holes in the lower hinge bracket to the corresponding holes on the opposite side of the cabinet. Insert and tighten screws.

7. Align the bottom hole on the lower left side of the door with the pin of the lower hinge and slide into place.

8. Align the pin of the top hinge with the top hole on the left side of the door and push in place. Replace the screws in the upper hinge bracket but do not tighten all the way.

9. Align the door from top to bottom and tighten the 2 screws on the top hinge.

10. Snap on the hinge box cover.

11. On some models you need to screw the hinge box cover using a phillips screw driver.

1. Use a flathead screwdriver to gently remove the plastic screw hole covers from the handle and the plastic hole plugs from the door.

2. Remove the door handle by unscrewing the upper and lower screws with a Phillips screwdriver.

3. Install the handle on the right side of the door with the screws previously removed.

4. Replace the plastic screw hole covers onto the door handle.

5. Replace the plastic door hole plugs on the side of the previously removed door handle.

• The fan circulating air inside the interior of the unit maintains the temperature you have selected.

• Boiling water, gurgling sounds or slight vibrations are the result of the refrigerant circulating through the cooling coils.

• Sizzling or popping sounds result from frost melting during the automatic defrost cycle and dripping onto the defrost heater.

• The sound of dripping water occurs as ice melts from the evaporator and flows into the drip pan during the defrost cycle.

• Cracking or popping sounds are caused by the expansion and/or contraction of the cooling coils during the defrost cycle.

• Both the defrost timer and the thermostat controls will click when they cycle ON and OFF.

Wipe the exterior of the freezer with a damp cloth and dry thoroughly. Use only mild soapy water to clean the door gasket. Never use harsh cleansers or scouring pads to clean any part of the freezer.

For efficient operation, dirt and dust should be removed from the rear and bottom of your freezer every 3 months.

• Turn the temperature control dial to “0” and unplug the freezer before cleaning.

• Carefully slide the freezer away from the wall slowly to avoid damaging the floor.

• Wipe dust from the back of the freezer and the outside of the compressor compartment with a clean dry cloth or use a vacuum cleaner with a brush attachment.

Note: Do not attempt to clean inside the compressor compartment.

Clean the inside of the freezer at least twice a year. Turn the temperature control dial to “0”, unplug the freezer and remove all frozen items from the shelves. Wash the inside with a solution of warm water and baking soda (2 tablespoons of baking soda to one quart of water), then rinse and dry thoroughly. Do not use cleaners such as harsh detergents, scouring powder or sprays containing bleach, ammonia, or other chemicals that may cause odors inside the freezer or damage the protective coating on the evaporator shelves.

Your freezer is frost-free. No defrosting is required as it is factory preset to automatically defrost.

For long vacations or absences, empty food from the freezer, move the temperature control dial to the OFF position and disconnect the power cord from the wall outlet. Clean the freezer and door gaskets according to the Proper Care and Cleaning section. Prevent odors from forming by placing an open box of baking soda in the freezer and propping the door open to allow air to circulate inside.

When transporting the freezer, it should be kept in an upright position. If the freezer is inadvertently tilted beyond 45 degrees or was laid down horizontally for any reason (e.g., shipping), the unit must not be operated for at least 24 hours. It must be placed in the upright position for 24 hours to allow the internal oil and refrigerant to stabilize in the system. Ignoring this precautionary measure may result in damage to the sealed system and compressor.

• The unit may not be plugged in.

• The circuit breaker may have tripped or the fuse may have been blown.

• The door may have been left open or there may be a leak in the door gasket.

• Frequent door openings allow cold air to escape, thus forcing the compressor to cycle ON more often.

• Air is not circulating freely around the appliance due to installation in an area with little or no clearance. Slide the appliance out of the confined area and vacuum around the rear and bottom to improve air circulation.

• Foods with strong odors should be tightly covered.

• Check for spoiled food.

• Interior may require cleaning.

• Keep an open box of baking soda in the freezer to absorb odors and replace as needed.

• The temperature setting is not high enough.

• The door has been left open for an extended period of time or there may be a leak in the door gasket.

• Overloaded shelves are preventing effective circulation of cold air.