GREENHOUSE FUSE AIR (01) PDF MANUAL

The FUSE AIR features a Power Button, a Temperature Control + button, a Temperature Control – button, and an OLED Display.

The FUSE AIR is designed for use with oils, dry herbs, and wax or concentrates. The instruction guide provides specific loading instructions for dry herb, and for wax and oil using the included Quartz Cup.

To power the FUSE AIR on or off, rapidly press the power button 5 times within 2 seconds. When turning off, be sure to press the on/off button 5 times within 2 seconds.

Load material into the heating chamber. Press the power button 5 times in rapid succession to turn the device on. The OLED screen will display the device’s current temperature. The indicator light will be RED when heating. Once the desired temperature is reached, the indicator light will turn to GREEN. The device will automatically shut off after 4 minutes when not in use. To reactivate the heating element, click the power button 5 times in rapid succession.

1. For best results, fill the chamber halfway or more, but do not pack tightly. This allows for even heat distribution and room to stir your herbal blends if necessary throughout usage.

2. To maximize efficiency, allow the unit to cool whenever possible after using, and then stir content before the next cycle.

3. Be sure to turn off the unit when you are done by pressing the on/off button 5 times within 2 seconds.

FUSE AIR logo: Indicates Turn On/Off status or activity.

Low Battery icon (battery with low bar): Indicates Low Battery.

Charging icon (battery with lightning bolt): Indicates Charging.

“Protect” text: Indicates an Error Occurred.

“Time 000S” and “000°F”: Indicates Auto Shutoff Countdown and current temperature.

“Set: 000°F” and “000°F”: Indicates Temperature Setting mode and set/current temperature.

Press and hold the power button and the “-” (minus) button simultaneously within 2 seconds to change the temperature display from Fahrenheit to Celsius degrees or from Celsius to Fahrenheit.

Adjust the desired temperature manually using the “+” (plus) or “-” (minus) buttons. The temperature range is 320°F-430°F.

Yes, the FUSE AIR is equipped with a 4-minute auto shutoff time (Safety Power Duration of 240 seconds) to prevent waste and overheating. The device will automatically shut off after 4 minutes when not in use.

To reactivate the heating element after an automatic shutoff, simply click the power button 5 times in rapid succession.

The FUSE AIR heats up in less than 30 seconds.

1. Push out the mouthpiece.

2. Load herbs loosely into the chamber.

3. Put the mouthpiece back, and you can begin vaping.

1. Remove the mouthpiece.

2. Pull off the silicone cap from the quartz cup.

3. Load wax or oil into the quartz cup.

4. Replace the silicone cap on the quartz cup.

5. Put the quartz cup into the device’s heating chamber.

6. Re-insert the mouthpiece, and you can begin vaping.

1. Push out the mouthpiece.

2. Remove the material from the chamber.

3. Use the cleaning brush to sweep the remaining residue from the chamber.

1. Push out the mouthpiece.

2. Pull off the old silicone from the mouthpiece.

3. Set a new silicone onto the mouthpiece.

4. Fully set the silicone onto the mouthpiece.

Always store the Fuse Air in a dry place to protect the device from excessive exposure to heat or cold.

1. The battery capacity is 1600mAh.

2. Initially charge the Fuse Air for 2 hours. The battery will stop charging when the battery icon on the display is full.

3. When the battery level is low (indicated by the low battery icon), charge the battery with the included micro-USB cable by attaching it to either your computer USB port or a compatible wall charger.

4. Do not use the Fuse Air while it is charging.

No, do not use the Fuse Air while charging.