GREENHOUSE ACACIA (01) PDF MANUAL

1 – Battery

1 – Ceramic Filter

1 – Mouthpiece

1 – Wall Adapter

1 – Chamber Connector

1 – Mesh Filter

1 – Cleaning Brush

1 – USB Charger

1 – Ceramic Heating Chamber

1 – Spring

1 – Packing Tool

The USB charger connects directly to any USB port. The wall adapter works in conjunction with the USB port.

1. We recommend charging your device for at least 6 hours during the first charge. This will condition the battery for its future uses.

2. When the LED display is blank, the device needs to be charged. Charge for approximately 2 hours. The LED will display while charging. When full, remove battery from charger. The light (or LED display) will turn green or indicate “Fully Charged” when the battery is fully charged.

1. Remove the chamber connector from the heating chamber.

2. Use the packing tool to gently pack the chamber with herb or wax material, but do not over-pack. (When using wax do not pack the wax)

3. Screw the chamber connector onto the heating chamber. With your device connected, you are now ready to vape!

1. With your device ready for use, press the power button to activate the heating element. Continuing to press the power button, put the mouthpiece into your mouth, and inhale lightly. Enjoy your experience!

2. Your device will automatically shut off after 9 seconds of continuously depressing the power button. Wait 3 seconds before activating again.

When using the device for an extended period of time, the filter may get clogged and dirty, causing a difficult draw or less vapor being released through the mouthpiece. To resolve this, you should clean the heating chamber, the ceramic filter, and the mouthpiece according to the cleaning instructions.

1. Disconnect from the battery.

2. Use the brush tool to gently clean the walls of the heating chamber.

3. Do not touch the heating element at the bottom of the chamber.

1. Insert a paper clip or pin into the holes.

2. Push all the way through to ensure clear airway. Wipe clean with a cloth.

1. Wipe the inside of the mouthpiece with a cotton swab.

2. Wipe the mouthpiece with a damp paper towel.

1. Remove mouthpiece from the chamber connector.

2. Unscrew the chamber connector from the heating chamber.

3. Turn the chamber connector upside down; the mesh filter should fall out easily. Use the spoon end of the packing tool to remove filter if necessary.

4. To remove the spring from the chamber connector, hold the top of the spring. Twist counter-clockwise and quickly pull it through the smaller opening of the chamber connector.

5. Device parts are very delicate. If they are stretched beyond their original size, they should be replaced.

1. Place the spring, smaller end first, into the chamber connector. Gently pull through from the other side until it is securely in place.

2. Place the filter inside the chamber with the mesh filter tool.

3. Use the packing tool to press the filter in firmly and evenly.

4. Screw the chamber connector to the heating chamber.

5. Insert the ceramic filter to the mouthpiece.

6. Connect the mouthpiece to the chamber connector. Make sure the mouthpiece is pushed all the way down into the chamber connector. If the mouthpiece doesn’t go all the way down, then the mesh filter is not laying flat and needs to be readjusted.

For best results do not over pack the heating chamber. This will ensure easy airflow passage for even heating.

Remember to press the power button for at least 2 seconds before inhaling to activate the heating element.

Between uses, wait 3 seconds before reactivating the device.

For best results, break the tobacco up by hand or grind them. Be sure to remove all stems and/or seeds before filling the heating chamber.

In the event that vapor isn’t being released, use the packing tool to gently rotate the tobacco within the chamber.

Do not fill the device with any stems, seeds or liquids. Doing so will cause damage to the device.

Let metal spring cool down at least 1 minute after use before touching it.

Do not drop the device.

Do not put the device into water or any other liquid.

Do not put any foreign objects into the device.