GREENHOUSE MUSE (01) PDF MANUAL

The MUSE device consists of the following main parts as identified in the device anatomy:

1 – Mouthpiece

2 – Air Intake Valves (also referred to as Air Intake)

3 – Multi-Function Button

4 – LED Indicator (which displays information like LED Charge status and LED Temperature Indicator)

1. Plug charging adapter into USB port and the other end of the cable into the unit.

2. The LED indicator will light up to show the charging status.

RED = unit is charging

GREEN = battery is fully charged

Click the button 5 times in 3 seconds to power on/off the vaporizer.

Press the button for 3 seconds to set the temperature. The button will remain red until it reaches the desired temperature. The LED indicator will turn colors based upon the temperature setting.

The LED indicator will turn colors based upon the temperature setting:

red = 360F

green = 380F

blue = 420F

The button blinks red five times when voltage is low, then the vaporizer powers off.

After the heating process begins, the vaporizer powers off automatically after 10 minutes.

1. Fully charge the unit.

2. Push the mouthpiece with your thumb to expose the heating chamber.

3. Grind tobacco if needed and place inside heating chamber. Do not overfill or pack too tightly as this will restrict airflow and produce negative results.

1. A slow and steady inhale will produce the best results.

2. If you’re unsatisfied with the amount of vapor being produced, try raising the temperature. If the vapor is too thick, try reducing the temperature.

1. Use only the included brush to clean material from the chamber. You may dampen the brush with water, but do not use cleaning solutions.

2. Unscrew screen, and clean or replace as needed.