ELDOM VELIORA PJ350 (01) PDF Document

Failure to comply with the following safety instructions may result in electric shock, fire and/or serious injury. Keep all warnings and security notices so you can use them in the future.

1. The connection cable must be plugged into a socket with the parameters specified in the instructions.

2. Do not immerse the cable or device in water.

3. Do not use outdoors.

4. Do not place the appliance near heat sources.

5. Do not leave children unattended near the appliance.

6. This equipment may be used by children of at least 8 years of age and by persons of diminished physical and mental capabilities and persons with inexperience and lack of familiarity with the equipment, if supervision or instruction is provided on how to use the equipment safely so that the associated risks are understood. Children should not play with the equipment. Unsupervised children should not carry out cleaning or maintenance of the equipment.

7. Before switching on the equipment, make sure that all its components are properly assembled.

8. Do not handle the equipment with wet hands.

9. NOTE: There is a possibility of injury due to improper use.

10. Always unplug the appliance if left unattended and before folding, unfolding or cleaning.

11. Do not use the appliance to grind ice, bones and other hard products or to grind nuts, coffee and dried legumes.

12. Do not grind hot products.

13. The appliance may only be used with the accessories originally supplied.

14. Do not touch the chopping tip knife and the chopping blade in the container while the appliance is in operation and only touch the blades after they have been switched off.

15. Do not exceed the appliance’s permissible continuous running time.

16. Do not use if the power cord is damaged, if the appliance has fallen or is otherwise damaged. Have the appliance repaired by an authorised service centre.

17. Any modernisation or use of non-original spare parts or appliance components is forbidden and endangers the safety of use.

CAUTION: A plastic bag can pose a risk of suffocation – to avoid this, keep it away from infants and young children.

Power: 250 W

Power voltage: 220-240V~50/60Hz

Acceptable continuous use: 30 min.

Break before resuming to use: 5 min.

1. Filter (soft, hard)

2. Auger

3. Juice collector

4. Pulp outlet

5. Micro switch

6. Drive shaft

7. Pulp container

8. Switch (ON, 0, REV)

9. Juice container

10. Housing

11. Valve

12. Juice outlet

13. Pusher

14. Lid with opening

15. Feeding tube

16. Tab

17. Brush

Before using the device, check if the unit, plug, and power cord are in good condition and all packaging materials have been removed.

Before first use, remove all packaging elements.

Before first use, wash all parts that come into contact with food thoroughly (see section: “Cleaning and Maintenance”).

1. Make sure the device is turned off (the switch (8) is in the “0” position) and unplugged from the power supply.

2. Place the juice collector (4) onto the housing (10).

3. Attach the valve (11) to the juice outlet (12).

4. Insert the auger (2) into the juice collector (6), then insert the filter (1).

5. The mark on the juice collector (6) should align with the mark on the filter (1).

6. Place the feeding tube (15) onto the juice collector (3); the mark on the tube (15) should align with the mark on the juice collector (3), then rotate the tube (15) to the right.

7. Close the lid (14) – the device will not operate unless the lid is properly closed.

8. Insert the pusher (13) into the hole in the lid (14).

9. Place the containers (7, 9) under the outlets (4, 12).

To disassemble the device, follow the steps in reverse order.

The set includes two filters for different purposes:

“soft” (gray) – filter with large holes – suitable for soft fruits and vegetables, e.g.: oranges, watermelon, grapes, tomatoes, blueberries, strawberries, etc.

“hard” (black) – filter with small holes – suitable for hard fruits and vegetables, e.g.: carrots, beets, celery, ginger, etc.

To obtain the best quality juice, the ingredients should be properly prepared:

– Peeled (if necessary) and washed fruits or vegetables should be cut into pieces that fit the feed chute in the lid (14).

– Long (e.g. carrots) or fibrous (e.g. pineapple) ingredients should be cut into shorter pieces.

– For best results, juice slowly – do not apply excessive force to the pusher, as this may reduce the quality of the juice.

– Excessive pressure on the pusher may not only impair juice quality but, in extreme cases, damage the juicer.

– Only soft fruits (e.g. apples or oranges) may be inserted whole.

WARNING: Inserting hard fruits/vegetables (e.g. beets) whole may damage the gear and auger assembly. Such damage is not covered by the warranty.

WARNING: The appliance will not operate if the lid (14) is not closed. Opening the lid (15) during operation will stop the appliance.

1. Place the assembled appliance on a stable, flat surface.

2. Plug the appliance into a power outlet that matches the parameters specified in the manual.

3. Ensure the juice container (9) is placed under the outlet (12) and the valve (11) is open.

4. Ensure the pulp container (7) is placed under the outlet (4).

5. Switch on the appliance by moving the power switch (8) to the “ON” position.

6. Insert the prepared ingredients in portions into the feed chute in the lid (14) and use the pusher (13) to gently push them down towards the rotating auger (2).

WARNING: Never insert fingers or any objects into the feed chute (15).

7. The juice will flow directly into the juice container (9), while the pulp will be collected in the pulp container (7).

8. The valve (11) located in the juice outlet (12) can be closed temporarily to change (empty) the juice container (9), or after use to prevent juice from dripping.

9. After all ingredients have been processed and the juice flow has stopped, switch off the appliance and wait until it comes to a complete stop.

10. Respect the appliance’s continuous operation time. Exceeding the operating time or failing to allow sufficient breaks may result in irreversible motor damage.

11. After use, clean the appliance according to the instructions in the Cleaning and Maintenance section.

Whole large ingredients, such as apples or oranges, can be inserted into the appliance.

1. To add a whole large ingredient, switch off the appliance (move the switch (8) to the “0” position), then open the lid (14).

2. Insert the large ingredient into the feed chute (15), then close the lid (14).

3. Switch on the appliance by turning the switch (8) to the “ON” position.

If the auger becomes blocked, switch the appliance to the “REV” position for 3 to 5 seconds. Repeat this process 2 to 3 times, then turn off the appliance and disassemble the parts to remove the blocking item.

– Use fresh fruits and vegetables, as they contain more juice.

– Thoroughly clean the fruits and vegetables before juicing.

– Remove hard, inedible skins (e.g., melon, pineapple, mango) as well as pits and hard seeds from the ingredients.

– Cut ingredients into small pieces. Long (e.g., carrots) or fibrous products (e.g., pineapple) should be cut into shorter pieces.

– NOTE: Fruits with small seeds (e.g., chokeberries, raspberries, currants) should be processed in small batches – about 0.5 kg. Before inserting the next batch, turn off the appliance and disassemble the parts for cleaning.

– Do not process ice.

– When juicing herbs or leafy vegetables, for optimal results, roll them into a bundle or combine them with harder ingredients.

– Apple juice darkens quickly. This process can be slowed down by adding a few drops of lemon juice.

– Processing very soft fruits can be difficult. When using bananas, for example, add them as the first or second ingredient. Banana nectar will flow along with the juice extracted from other fruits.

After processing ingredients, you can perform a preliminary cleaning of the appliance. To do this, while the appliance is operating, pour clean water into the opening in the lid (14).

If you want to change the type of processed ingredients (to avoid mixing juices), preliminary cleaning allows you to rinse the juicer without having to disassemble the entire appliance.

CAUTION: None of the device components are dishwasher safe.

WARNING: Before starting the cleaning process, switch off the appliance by turning the switch (8) to position “0” and unplug it from the power supply.

1. Remove the pusher (13).

2. Unlock (turn left) the feeding chute (15) and remove it from the collector (3).

3. Remove the juice collector (3) together with the filter (1) and auger (2) – wash the components in warm water with a small amount of dishwashing liquid using the cleaning brush (17), then rinse under running water.

4. The housing (10) can be cleaned with a slightly damp cloth and wiped dry.

WARNING: Do not immerse the housing (10) in water.

WARNING: Do not use any sharp, metal tools or chemical agents to clean and maintain the appliance.