Free English DRUCK UNIK5600 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD DRUCK UNIK5600 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What procedures does this manual for the DRUCK UNIK5600 contain?
This manual contains the removal and installation procedure for the backend of the demountable KYNAR cable and demountable TPE-U cable version of the DRUCK UNIK5600/5700.
What should be done before starting the installation procedure for the DRUCK UNIK5600?
Read the whole installation procedure before starting installation. The technical specification is detailed in the datasheet.
Who should perform the operations described in the manual for the DRUCK UNIK5600?
All the operations described in this manual should only be performed by trained and authorized professionals.
What personal protective equipment should be worn when completing the procedure for the DRUCK UNIK5600?
Always wear the necessary personal protective equipment when completing this procedure.
What warning should be observed regarding hazardous areas when working on the DRUCK UNIK5600?
Do not complete this procedure in a hazardous area while an explosive atmosphere is present – THIS CAN CAUSE AN EXPLOSION. Isolate the power supply to the equipment first.
What accessories and tools are required for the installation of the DRUCK UNIK5600?
The required accessories and tools are:
Torque wrench (1.8 Nm)
2.5mm Hexagon bit
O-ring (163M2956-1)
What are the steps for the Disassembly Procedure for the backend of the DRUCK UNIK5600?
1. Remove the screws and spring washers.
2. Separate the flange and unplug the connector. Make sure the flying leads are not pulled out from the connector.
What is the part number for the O-ring that needs to be replaced when reassembling the backend of the DRUCK UNIK5600?
The part number of the O-ring is 163M2956-1.
What are the steps for the Re-assembly procedure after exchanging the O-ring for the DRUCK UNIK5600?
1. Exchange O-ring and put it into the seal groove. Make sure the O-ring is fully seated in the groove. Please always replace with a new O-ring when reassembling the backend. The part number of the O-ring is 163M2956-1.
2. Reconnect the connector, ensuring correct alignment. Please pull back slightly to make sure it is not pulled out and fully fixed.
3. Assemble the screws and spring washers. Ensure screws and washers are undamaged before installing.
4. Put the screws and spring washers into the screw holes of the flange and pre-tighten 4 turns. Alternately tighten each diagonally opposite pair of screws to a torque of 1.8 Nm. Ensure screws and washers are clean before installing. The screws and washers cannot be used if they are damaged.
What is the required torque for tightening the screws when reassembling the DRUCK UNIK5600 backend?
The screws should be alternately tightened each diagonally opposite pair to a torque of 1.8 Nm.
What must be done to verify the DRUCK UNIK5600 after reassembly?
Please verify sensor operation after reassembly.
CLICK HERE TO DOWNLOAD DRUCK UNIK5600 (01) PDF DOCUMENT