Free English DRUCK DPI620PC (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD DRUCK DPI620PC (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What components are included in the DRUCK DPI620PC Pressure Calibrator Package?
The DRUCK DPI620PC package contains the following items:
DPI620G Genii Calibrator
PV621G Pressure Generation Station
PM620 Pressure Module
4Sight2 Calibration Management Software
How do I install the battery in the DRUCK DPI620PC?
To install the IO620-BATTERY in your DRUCK DPI620PC, follow these steps:
Step 1. Remove the five Pozidriv screws (A) from the device.
Step 2. Remove the battery cover.
Step 3. Align the battery connections with the connections located in the battery compartment.
Step 4. Place the battery into the battery compartment.
Step 5. Replace the battery cover.
Step 6. Secure the cover back in place with the five Pozidriv screws (A).
Step 7. Connect the battery charger and allow the battery to fully charge before initial use.
How do I charge and attach the battery for the intrinsically safe version of the DRUCK DPI620PC?
For the intrinsically safe components of the DRUCK DPI620PC package, follow these procedures for the IO620G-IS-BATTERY:
To charge the battery:
Step 1. Fit the battery to the battery cradle.
Step 2. Connect the battery charger and allow it to fully charge before use.
To attach the battery to the calibrator:
Step 1. Align the battery with the Intrinsically Safe Calibrator.
Step 2. Secure the battery to the calibrator using the provided thumb screws.
How is the DRUCK DPI620PC Pressure Calibrator set up for operation?
To set up the DRUCK DPI620PC Pressure Calibrator, follow these assembly steps:
Step 1. Place the Calibrator unit onto the Pressure Generation Station and latch it into position.
Step 2. Hand tighten the Pressure Module into the sensor port of the Pressure Generation Station.
Note: For the intrinsically safe version of the DRUCK DPI620PC, place the Intrinsically Safe Calibrator onto the Intrinsically Safe Pressure Generation Station until it latches, then hand tighten the Intrinsically Safe Pressure Module into the sensor port.
How do I install the 4Sight2 Calibration Management Software for the DRUCK DPI620PC?
To install the software for the DRUCK DPI620PC:
Step 1. Refer to the instructions provided in the software quick start guide.
Step 2. Contact the manufacturer to unlock the Lite license for the software.
What are the primary components of the DRUCK DPI620PC Intrinsically Safe Package?
The intrinsically safe version of the DRUCK DPI620PC includes the following items:
DPI620G-IS Intrinsically Safe Calibrator
PV621-IS Intrinsically Safe Pressure Generation Station
PM620-IS Intrinsically Safe Pressure Module
4Sight2 Calibration Management Software
CLICK HERE TO DOWNLOAD DRUCK DPI620PC (01) PDF DOCUMENT