DJI MIC 3 (02) PDF Document

The main components of the DJI MIC 3 transmitter (TX) are:

1. Recording Status LED

2. Charging Contacts

3. System Status LED

4. Power Button

5. Linking Button

The buttons on the DJI MIC 3 transmitter have the following functions:

Power Button:

– Press and hold for 2 seconds to power the transmitter on or off.

– Press once (x1) to start or stop recording.

– Press twice (x2) to mute or unmute the microphone.

Linking Button:

– Used to initiate pairing with a receiver or other compatible device.

The main components of the DJI MIC 3 receiver (RX) are:

1. USB-C Port

2. Charging Contacts

3. Monitor Port

4. Output Port

5. Touchscreen

6. Dial

7. Power Button

8. Release Button

The main components of the DJI MIC 3 charging case are:

1. Battery Level LEDs

2. USB-C Port

To connect the DJI MIC 3 receiver (RX) to a mobile phone, follow these steps:

Step 1. Select the appropriate mobile phone adapter (USB-C or Lightning) from the charging case.

Step 2. Slide the adapter into the port on the receiver (RX) until it clicks in place.

Step 3. Plug the receiver with the attached adapter into your mobile phone’s port.

Step 4. Clip the transmitters (TX 1 and TX 2) onto your clothing to begin recording audio.

To connect the DJI MIC 3 receiver (RX) to a camera, follow these steps:

Step 1. Attach the receiver (RX) to the camera’s hot shoe mount.

Step 2. Connect the included 3.5mm TRS cable from the Output Port (OUT) on the receiver to the microphone input (MIC-IN) port on your camera.

Step 3. Clip the transmitters (TX 1 and TX 2) onto your clothing to begin recording audio.

You can wear or attach the DJI MIC 3 transmitter (TX) in the following ways:

– Use the integrated clip to attach it directly to clothing, like a shirt collar or lapel.

– Use the back magnet to secure it to clothing or a metal surface.

– For outdoor recording in windy conditions, place the transmitter inside the included windscreen before clipping it on.

To pair the DJI MIC 3 transmitter (TX) directly via Bluetooth with compatible devices such as the Osmo Action 4, Osmo Action 5 Pro, or Osmo Pocket 3, press and hold the linking button on the transmitter for 2 seconds. This will put the transmitter into pairing mode.