D-LINK DCS-1130 (02) PDF MANUAL

D-LINK DCS-1130 (02) PDF SUMMARY:

What does the installation CD include?

The installation CD includes a set-up wizard and technical manuals.

What does the packaging of the Wireless N Network Camera DCS-1130 include?

The packaging includes the Wireless N Network Camera DCS-1130 plus antennas, a power adapter, an Ethernet cable (CAT5 UTP), and a mounting kit.

What should I do if any of the items are missing from the packaging?

If any items are missing from the packaging, contact your reseller.

How do I set up the product using the CD?

Insert the CD into the CD drive of your computer, the set-up wizard should start automatically. Make sure that your internet connection is active. (Do not plug in DCS-1130 yet). Then, select your language from the list of options and follow the steps within the wizard to complete the set-up of DCS-1130.

How do I configure the DCS-1130 using a static IP address?

Connect your DCS-1130 directly to your computer’s ethernet port using the ethernet cable provided. Ensure that your computer is also set to a static IP address of type 192.168.0.x. Then connect the power cable on the DCS-1130. The DCS-1130 power light will display as solid red first, then shortly turn to green. Then open a browser window and enter the IP address http://192.168.0.20 in the browser address field, with the username ‘admin’ and a blank password.

How do I reset my DCS-1130 to factory default settings?

Ensure the DCS-1130 is powered on. Push and hold a paperclip in the reset hole for 10 seconds, then release it. The camera will then reset to factory default settings.

How do I configure my DCS-1130 without the CD?

Connect your PC to the router using an Ethernet cable. Log on to D-Link support site http://support.dlink.com.tw. Download the Setup Wizard SE utility from the DCS-1130 section under technical support. Install and run the Setup Wizard utility SE. The default username is ‘admin’, and the default password is blank.

What do I do if I have changed the password and can not remember it?

You will need to reset the DCS-1130 to set the password back to blank.

What is the default IP address if the DCS-1130 cannot find a DHCP server?

The default IP address is http://192.168.0.20.

What can I do if my DCS-1130 is not working correctly?

Try using the wizard on the included CD. To make sure your hardware is installed correctly, make sure that:

• The front LED is lit solid green
• Your Internet connection is working
• Your router’s LAN & WAN connections are ok
• Your router supports UPnP®
• Your camera is on the same network as your PC
• Both your PC and camera have a working Internet connection

If your camera is still not working, check your router and make sure it is using the latest firmware.

I do not have a router. How do I install my DCS-1130?

Connect the camera directly to the computer’s Ethernet port. Assign your computer a static IP address within the same range as the camera, such as 192.168.0.x. Access and set up your camera via the default IP address of http://192.168.0.20.