CTA DIGITAL PAD-HSFK10 (01) PDF DOCUMENT

If the hinges on your CTA DIGITAL PAD-HSFK10 get looser and droop over time, please tighten the screws for optimum usage and efficiency.

To install your device, use the provided keys to open and lock the tablet enclosure. Turn the key clockwise for locking and counter-clockwise for unlocking.

1. Insert the key into the lock at the enclosure rear.

2. Turn the key counter-clockwise to unlock.

3. Insert the tablet and route the charge cable with the cable management system through the cutout at the rear.

4. Shut the enclosure and turn the key clockwise and remove it to lock.

For the iPad 10.5″, stick the attached thin round pad on each of the round pads to ensure the perfect fit.

The CTA DIGITAL PAD-HSFK10 allows you to route the cable through the pole for cable management.

1. Put the top pole to the lowest position, insert the cable into the cable routing on the bottom pole and push inward.

2. Draw out the top pole and continue to push inward the cable until the cable head is visible through the cable routing on the top pole.

3. Draw out the cable head from the cable routing on the top pole.

1. Insert the pole into the center of the heavy duty base.

2. Place the metal washer over the tightening screw rod, then screw it into the bottom side of the stand base center, turning clockwise to tighten.

It is important to connect the wheels to the stand base before attaching the pole.

1. Screw the wheels into the floor base by hand.

2. Use the provided wrench to tighten the wheels.

1. Place the battery case over the metal connection on the pole.

2. Place the gooseneck over the metal connection then turn clockwise to screw down until tight.

3. Use the smaller Star Allen key to tighten the small star meter screw inside the gooseneck. Note: if the meter screw is already in, unscrew it before attaching the gooseneck in step 2.

1. Use the included Allen key to tighten and loosen the gooseneck to holder connection screw to adjust the ease of rotation (360° and 270° rotation).

2. Rotate the plastic grip (height adjustment knob) to adjust the pole to your desired height. Flex the gooseneck freely to adjust your favorite view angle.