CHIQ CSF184S (01) PDF MANUAL

CHIQ CSF184S (01) PDF SUMMARY:

What should I do before operating the freezer?

Read all instructions before operating the freezer and do not attempt to repair or modify this unit in any way as it can cause harm or void the warranty.

---

What should I do when unpacking the appliance for the first time?

Keep all cardboard and plastic packaging out of reach from children and report any notable defects with the appliance to Changhong or retailer as soon as it is noted. Failure to do so can result in a non-warranty claim. Keep all packaging materials in a safe location until the unit has been properly installed.

---

What should I do if the power cord is damaged?

If the supplied power cord of this unit is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified persons in order to avoid any risk of injury.

---

How should I unplug the appliance?

Do not unplug the appliance without switching the unit off from the outlet first or by yanking the cord.

---

What should I do if I am discarding this unit?

Remove the door/s from the unit. Leave the shelves in place so that children may not easily climb inside. Never allow children to operate, play with, or crawl inside the freezer.

---

How should I dispose of this appliance?

Only dispose of this appliance at an authorized waste disposal center.

---

What should I never do when cleaning the freezer?

Never clean the freezer or freezer parts with flammable fluids, or store gasoline or any other flammable vapors and liquids in the vicinity of this or any other freezer as the gas and/or vapor can cause a fire hazard, explosion or inhalation.

---

What should I make sure of when installing or moving the unit?

Make certain, when installing or moving the unit that the power outlet has been connected to, has been fitted by a qualified electrician and the ground wire has been connected properly to meet the Australian Electrical Standards.

---

What warnings should I be aware of regarding the R600a refrigerant?

• This appliance contains 0.043kg R600a refrigerant which is environmentally friendly, but flammable.
• During transportation and installation, ensure that the tubing of the refrigerant circuit is not damaged.
• Leaking refrigerant can ignite and may damage the eyes.
• In the event any damage does occur, avoid exposure to open fires and any device which creates a spark. Disconnect the appliance from the mains power.
• Thoroughly ventilate the room in which the appliance is located for several minutes.
• Notify Customer Service for necessary action and advice.
• The room for installing the appliance must be at least 1 cubic metre per 8 grams of refrigerant.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

---

What is hazardous to do regarding servicing or repairs to this appliance?

It is hazardous for anyone other than an Authorised Service Person to carry out servicing or repairs to this appliance. In Queensland the authorized person must hold a Gas Work Authorisation for hydrocarbon refrigerants, before carrying out servicing or repairs which involve the removal of covers.

---

What should I ensure about the ventilation openings?

Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

---

What should I not use to accelerate the defrosting process?

Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

---

What should I not do to the refrigerant circuit?

Do not damage the refrigerant circuit.

---

What should I not use inside the food storage compartments?

Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

---

What should I not store in the appliance?

Do not store explosive substances such as aerosol cans with a flammable propellant in the appliance.

---

What should I consider when disposing of this appliance?

The environment and personal safety must be considered when disposing of this appliance. Please ensure the appliance is taken to a recycle center for safe recycling. DO NOT dispose of the appliance in land fill as the insulation and refrigerant gas contained in these appliances are flammable.

---

What should I do before using the freezer?

Remove the exterior and interior packing. Before connecting the freezer to a power source, let the unit stand upright for approximately 4 hours to mitigate the possibility of a malfunction in the cooling system from improper handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.

---

How should the freezer be installed?

This appliance is designed to be free standing only, and should not be recessed or built-in. Place the freezer on a leveled/even floor surface that is strong enough to support the weight of the freezer when it is fully loaded to prevent vibrations and allow water to properly drain. The front feet can be adjusted to level the appliance properly. The leveling feet should only be used in forward and backward motions and never side to side. Allow at least 5cm of space between the back and sides of the freezer to allow proper air ventilation. Adjust the two front feet to keep the freezer leveled or elevated. Situate the freezer away from direct sunlight and sources of direct heat (stove, heater, radiator, etc.). Direct sunlight may also affect the acrylic coating and heat sources may cause an increase electrical consumption. Ambient temperature below 50°F or above 85°F will hinder the performance of this appliance. This unit is not designed for outside installation. Avoid situating the freezer in moist OR pest infestation areas.

---

What should I do about the power cord?

Plug the freezer into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center.

---

What should I do after plugging in the appliance?

After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 2~3 hours before placing food in the freezer or freezer compartment.

---

What should I not place on top of the appliance?

Do not place items on the top of this appliance.

---

What are some energy saving tips?

• Allow hot foods to cool to room temperature before placing in the freezer.
• Do not adjust the temperatures colder than necessary.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the freezer.
• Organize and label food to reduce door openings and extended searches.
• Refrain from leaving the door/s open for a long time to conserve energy.

---

How do I adjust the temperature?

Press the temperature control key. Press it once and temperature will change 1 ° C accordingly. Temperature adjustment range:-16℃~-24℃. The digital display is cycled as follows: -16℃→-…→-24℃→-…→-16℃.

---

How do I use the quick-freeze function?

Press the quick-freeze key, the freezer will enter the fast freeze mode, the fast freeze indicator will light up, the digital display will show -24℃ . In the fast freeze mode, the temperature setting can’t be changed. Press the key again, the freezer will quit the fast freeze mode, fast freeze indicator will turn off, the temperature will restore to original setting. After the freezer runs in fast freeze mode for 3 hours, the freezer will quit the fast freeze mode automatically.

---

What should I do if the unit is unplugged or loses power?

If the unit is unplugged or loses power, please wait approximately 3 to 5 minutes before restarting the unit. If there is any attempt to restart before this time delay, the freezer will not commence operation.

---

What can hinder the cooling efficiency of the appliance?

Large quantities of food stored in the appliance or directly in front of the air vent will hinder the cooling efficiency of the appliance as this can affect the airflow.

---

How long should I wait for the temperature to stabilize between adjustments?

Allow 24 hours for temperature to stabilize between adjustments. Do not keep opening and closing the door once increasing the temperature.

---

How should I clean the freezer?

Turn off the freezer and then unplug the unit from the wall outlet. Remove all food content before washing the inside with a damp cloth soaked in lukewarm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a liter of water. Be sure to keep the door gasket (seal) clean to keep the unit running efficiently as improper cleaning can cause the seal to dislodge and tear. The exterior of the freezer should be cleaned with mild detergent and warm water. Dry the interior and exterior with a soft cloth. The condenser coils should be vacuumed when they are dusty or dirty.

---

What should I not do regarding the water tray above the compressor?

Don’t need to remove the water tray above compressor to empty water that will be evaporated by heat from compressor.

---

What should I do when going on vacation?

Turn off the freezer first and then unplug the unit from the wall outlet. Remove all food. Clean the freezer. Leave the lid open slightly to avoid possible formation of condensation, mold, or odors. Use extreme caution in the case of children. The unit should not be accessible to child’s play.

• Short vacations: Leave the freezer operating during vacations of less than three weeks.
• Long vacations: If the appliance will not be used for several months, remove all food and unplug the power cord. Clean and dry the interior thoroughly. To prevent odour and mold growth, leave the door open slightly: blocking it open if necessary or have the door removed.

---

How do I reposition and relocate the freezer?

Turn off the freezer first and then unplug the unit from the wall outlet. Remove all the food and drinks. Securely tape down all loose items inside your freezer. Tape the doors shut. Be sure the freezer stays in the upright position during transportation.

---

What should I do if the freezer does not operate?

Check if the power cord isn’t plugged in properly or if the circuit breaker tripped or a blown fuse.

---

What should I do if the compressor runs all the time?

• Check if the room temperature is hotter than normal.
• A large amount of food has been added to the freezer.
• The door is opened too often.
• The door is not closed completely.
• The temperature control is not set correctly.
• The door gasket does not seal properly.
• The freezer does not have the correct clearances.
• The freezer has recently been disconnected for a period of time. 4+ hours are required for the freezer to cool down completely pending on operating conditions.

---

What should I do if the temperature inside the freezer is too warm?

• Check if the temperature control is set incorrectly. Turn the control to a cooler setting and allow several hours for the temperature to stabilize.
• Set the freezer control back to mid position.
• If the door is kept open too long or is opened too frequently open the door less often.
• Make sure the door is not closed completely.
• Make sure the door gasket does not seal properly.
• If a large amount of warm or hot food might have been stored recently wait until the freezer has had a chance to reach its selected temperature.
• If the freezer has recently been disconnected for a period of time, allow 4 hours for the freezer to cool down completely.

---

What should I do if the temperature inside the freezer is too cold?

• Set the freezer control back to mid position.
• Check if the temperature control is set too cold. Turn the control to a warmer setting and allow several hours for the temperature to stabilize.

---

What should I know about the temperature of the external freezer surface?

The exterior freezer walls can be as much as 30F warmer than room temperature. This is normal while the compressor works to transfer heat from inside the freezer cabinet.

---

What does a popping or cracking sound when the compressor comes on mean?

Metal parts undergo expansion and contraction, as in hot water pipes. This is normal. Sound will level off or disappear as freezer continues to run.

---

What does a bubbling or gurgling sound like water boiling mean?

Refrigerant (used to cool freezer) is circulating throughout the system. This is normal operation.

---

What should I do if the freezer is vibrating?

• Check the freezer is on a level/even surface.
• Check if the floor is uneven or weak. Be sure floor can adequately support freezer.
• Level the freezer by putting wood or metal shims under part of the freezer.
• Make sure the freezer is not touching the wall. Re-level the freezer and move it from the wall.

---

What should I do if moisture forms on inside freezer walls?

• Weather is hot and humid, which increases internal rate of frost build-up. This is normal.
• Make sure the door is not slightly open.
• Make sure the door is not kept open too long, or is opened too frequently. Open the door less often.
• Make sure the door is sealed properly.

---

What should I do if moisture forms on the outside of the freezer?

The door is slightly open, causing cold air from inside the freezer to meet warm moist air from the outside.

---

What should I do if the doors will not close properly?

• Make sure the freezer is on a level surface.
• The gasket/s may be dirty or not properly maintained. Clean the seals and make sure they are dry before closing the door/s.
• The storage basket and/or shelves are out of position.

---

Who should I call for any enquiries?

Call the CHiQ Customer care on: 1300 796 688.