BRAUN SERIES 3 5416 (01) PDF Document

To charge the BRAUN SERIES 3 5416, use the special cord set to connect the shaver or the charging stand to an electrical outlet while the motor is switched off.

For the first charge or when the BRAUN SERIES 3 5416 has not been used for a few months, leave it to charge continuously for 4 hours.

Once fully charged, discharge the shaver through normal use, then recharge to full capacity. Subsequent charges will take about 1 hour.

A 5 minute quick charge is sufficient for a single shave.

The recommended ambient temperature for charging is 41 degrees Fahrenheit to 95 degrees Fahrenheit (5 degrees Celsius to 35 degrees Celsius).

The green charging light shows the charge status of the batteries. It blinks when the BRAUN SERIES 3 5416 is being charged or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is connected to an electrical outlet.

The red low charge light flashes when the battery is running low. You should be able to finish your shave.

Press the on/off switch to operate the BRAUN SERIES 3 5416. The flexible shaving foils automatically adjust to every contour of your face.

To trim sideburns, a moustache, or a beard, slide the long hair trimmer upwards.

For precise handling in hard to shave areas, such as under the nose, slide the precision mode switch on the BRAUN SERIES 3 5416 to the right position. This will cause one foil to be lowered.

To achieve the best results with the BRAUN SERIES 3 5416, follow these three steps:

1. Always shave before washing your face.

2. Always hold the shaver at right angles (90 degrees) to your skin.

3. Stretch your skin and shave against the direction of your beard growth.

To clean the BRAUN SERIES 3 5416 under running water:

1. Switch the shaver on in cordless mode.

2. Rinse the shaver head and the precision mode switch under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

3. Switch off the shaver, remove the Foil and Cutter cassette, and let it dry.

If you regularly clean the shaver under water, apply a drop of light machine oil once a week onto the long hair trimmer and the Foil and Cutter cassette.

The shaver should be cleaned after each usage with foam.

To clean the BRAUN SERIES 3 5416 using a brush:

1. Switch off the shaver.

2. Remove the Foil and Cutter cassette and tap it out on a flat surface.

3. Using a brush, clean the inner area of the shaver head. Do not clean the Foil and Cutter cassette with a brush as this may damage it.

The replacement light for shaving parts will come on after about 18 months or when worn to remind you to replace the Foil and Cutter cassette. After you have replaced the Foil and Cutter cassette on your BRAUN SERIES 3 5416, press the on/off switch for at least 5 seconds to reset the counter. The replacement light will blink and then go off when the reset is complete.

To maintain the optimum capacity of the rechargeable batteries in the BRAUN SERIES 3 5416, the shaver should be fully discharged by normal use approximately every 6 months, and then recharged to full capacity.