BISSELL CROSSWAVE CORDLESS 2551 (02) PDF DOCUMENT

Refer to the enclosed user guide for complete instructions and important safety notices.

First, insert the handle at the top of the body of the machine until you hear a “click”.

Place your CrossWave Cordless onto the 3-in-1 Docking Station to charge. For maximum run time, charge the unit for 4 hours prior to use.

For small area cleaning (less than 350 sq ft), fill the Clean Water Tank with warm tap water to the first water fill line. Then add formula to the first formula fill line.

For large area cleaning (up to 700 sq ft), fill the Clean Water Tank with warm tap water to the second water fill line. Then add formula until you get to the second formula fill line. Screw the cap back onto the Clean Water Tank.

On the back of the machine, align the Clean Water Tank with the grooves and slide the tank into place until you hear a “click”.

Turn the machine ON by selecting the type of floor you will be cleaning. For hard floors, choose the HARD FLOOR button and for area rugs push the RUG button.

Each time you use the product, hold the solution trigger for 10 seconds to prime the system with cleaning solution before you begin cleaning. When you hold the trigger, LED lights will illuminate.

When solution is flowing, you will see bubbles forming at the edges of the brush roll window.

You are ready to start cleaning. When you’re ready to clean, hold the trigger on both the forward and backward pass for great cleaning results.

For the best results, flush the unit by using the 3-in-1 Docking Station and holding down the Clean Out Cycle button on the carry handle. Then, rinse the Dirty Water Tank, Strainer, Brush Roll, and Brush Chamber. After allowing your machine and components to dry completely, reassemble everything, making sure the machine’s brush window is securely in place before using your machine next time.

On hard floors, there is no need to vacuum before using CrossWave® Cordless. This machine vacuums and washes at the same time.

To dry floors faster, release the trigger and run the machine over the floor without dispensing solution.

When cleaning area rugs, remove any excessive mud from your area rug prior to using your CrossWave Cordless.

When cleaning excessively dirty or muddy hard floors, or if the Brush Roll looks dirty, use the 3-in-1 Docking Station to rinse the Brush Roll before cleaning your area rugs.

For overly challenging and stuck-on messes on hard floors, activate the RUG mode and hold your CrossWave® Cordless over the mess. Using short passes while holding the trigger allows the multi-surface brush to go to work.