Free English ASPIRE VILTER FUN (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD ASPIRE VILTER FUN (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What is included in the contents of the ASPIRE VILTER FUN kit?
The contents include:
1 * Aspire Vilter Fun Device
1 * Vilter Pod (2.0 ml)
1 * POM Drip Tip
3 * Filter Drip Tip
1 * Type-C Cable
1 * User Manual
What are the technical specifications of the ASPIRE VILTER FUN?
The specifications for the device are as follows:
| Dimensions (including POM drip tip) | 91.5*26*17 mm |
| Pod Capacity | 2.0 ml |
| E-liquid Filling | Bottom filling |
| Coil | 1.0Ω mesh coil, non-replaceable |
| Battery Capacity | 400 mAh |
| Output | 3.7V constant output |
| Activation | Auto-draw |
| Charging | Type-C, 5V, 0.5A |
How do I fill the pod with e-liquid on the ASPIRE VILTER FUN?
Follow these steps to fill the pod:
1. Pull to remove the pod from the device.
2. Lift the silicone seal at the bottom of the pod.
3. Add e-liquid.
4. Insert the silicone seal back firmly.
5. Place the pod back into the device.
Note: When filling a new pod, let the pod stand for 5 minutes after filling so the cotton can be saturated with e-liquid before use.
What do the indicator lights mean on the ASPIRE VILTER FUN?
| Status of Indicator Light | Device |
| Vaping | White light is on |
| Stop vaping | Light turns off |
| Insert / Remove Pod | White light flashes 1 time |
| Charging | White light is on |
| Fully charged | Light flashes 20 times and turns off |
What are the protection features indicated by the light on the ASPIRE VILTER FUN?
| Protection Features | LED Status |
| Over-time Protection (6S) | Flash white 10 times |
| Short Circuit Protection | Flash white 2 times |
| Low Voltage Protection | Flash white 10 times |
| Overcharge Protection | Device stops charging |
How do I charge the ASPIRE VILTER FUN?
To charge the device:
Use the Type-C cable to charge the device.
Maximum charge current: 500 mA.
Charge voltage: 5V.
When the Type-C cable is connected, the light flashes 3 times.
What type of coil does the ASPIRE VILTER FUN use and is it replaceable?
The device uses a 1.0Ω mesh coil. The coil is non-replaceable.
What are the safety recommendations regarding the battery and charger for the ASPIRE VILTER FUN?
Use only certified chargers, accessories, and supplies. Do not use a third-party accessory or supply that has not been approved for use with the device.
Do not use the device if it is overheating or the battery is deformed.
Do not use the device if the battery casing is damaged.
The device and its accessories are not drying appliances. Do not dry them with an external heat source such as a microwave oven or hair dryer.
Dispose of the device and its accessories in accordance with local regulations.
CLICK HERE TO DOWNLOAD ASPIRE VILTER FUN (01) PDF DOCUMENT