ASPIRE MINI NAUTILUS (01) PDF Document

The contents of the kit include:

* 1 2ml Mini Nautilus Tank (1.6 ohm BVC atomizer pre-installed)

* 1 replacement BVC atomizer (1.8 ohm)

* 1 eGo threaded cone

* 1 user manual

1. Screw the upper hardware to the Pyrex tank (DO NOT over tighten!).

2. Screw the BVC Atomizer into the bottom hardware (make sure the BVC atomizer is snugged down hand tight).

3. Snugly screw the Tank hardware to the bottom Atomizer hardware (the atomizer screws onto the air-tube shaft in the center).

4. Insert the drip-tip into the upper hardware.

1. Check to make sure the upper stainless steel component is screwed tightly onto the glass tank.

2. Unscrew the bottom hardware from the upper hardware.

3. Fill liquid into the space between the glass tank and the center metal tube. DO NOT over fill or get liquid into the center shaft. Do not fill the liquid into the central hole.

4. Screw the bottom hardware back onto the upper hardware.

When you unscrew the bottom hardware, the atomizer should be unscrewed from the upper hardware at the same time. In some cases, the atomizer will remain attached to the air-tube shaft in the center. If this happens, please unscrew the atomizer from the upper hardware and screw it back into the bottom hardware.

Let the ASPIRE MINI NAUTILUS stand for 2 minutes before use. This will allow the e-liquid to absorb into the atomizer chamber.

Screw the eGo threaded cone onto the battery, and then install the ASPIRE MINI NAUTILUS onto the battery.

If you experience a burning taste during the first couple of puffs, it is because the liquid has not fully absorbed into the atomizer. Please give the liquid time to fully absorb and try again.

The ASPIRE MINI NAUTILUS unique four-port airflow valve features 4 different sizes to control the airflow of your tank. Rotate the Airflow control valve to your desired port size. This allows the user to adjust the draw, warmth of vapor, and amount of vapor produced.

The airflow hole sizes are:

1. Ø0.9mm

2. Ø1.1mm

3. Ø1.4mm

4. Ø1.8mm

When necessary, clean the components (except the BVC Atomizer) by washing with clean water, and air-drying.

1. The glass tank should not be impacted, dropped, or mishandled, otherwise the glass tube may be broken, and injury may occur.

2. When disassembling, please remove the bottom hardware first, and then screw off the glass tank.

3. Do not fill the ASPIRE MINI NAUTILUS over 2ml; when the liquid level is below 0.5ml, the tank should be refilled to avoid a burning taste.

If the bottom hardware is hard to screw off, please screw the upper hardware with the glass tank tighter. The bottom hardware will then be easier to unscrew.